Abatement of contaminants of emerging concerns (CECs) in water sources has been widely studied employing TiO₂ based heterogeneous photocatalysis. However, low quantum energy yield among other limitations of titania has led to its modification with other semiconductor materials for improved photocatalytic activity. In this work, a 0.05 wt.% CuWO₄ over TiO₂ was prepared as a powder composite. Each component part synthesized via the sol-gel method for TiO₂, and CuWO₄ by co-precipitation assisted hydrothermal method from precursor salts, underwent gentle mechanical agitation. Homogenization of the nanopowder precursors was performed by zirconia ball milling for 2 h. The final material was obtained after annealing at 500 °C for 3.5 h. Structural and morphological characterization of the synthesized material has been achieved employing X-ray diffraction (XRD), Fourier transform infra-red (FTIR) spectroscopy, Brunauer–Emmett–Teller (BET) N₂ adsorption–desorption analysis, Scanning electron microscopy-coupled Energy dispersive X-ray spectroscopy (SEM-EDS), Transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and UV-Vis diffuse reflectance spectroscopy (UV-vis DRS) for optical characterization. The 0.05 wt.% CuWO₄-TiO₂ catalyst was investigated for its photocatalytic activity over carbamazepine (CBZ), achieving a degradation of almost 100% after 2 h irradiation. A comparison with pure TiO₂ prepared under those same conditions was made. The effect of pH, chemical scavengers, H₂O₂ as well as contaminant ion effects (anions, cations), and humic acid (HA) was investigated, and their related influences on the photocatalyst efficiency towards CBZ degradation highlighted accordingly.

The increasing use of pharmaceuticals, their presence in the aquatic environment, and the associated toxic effects, have raised concerns in recent years. In this work, a new multi-residue analytical method was developed and validated for the determination of 10 pharmaceuticals in wastewaters using online solid-phase extraction (online SPE) and liquid chromatography-tandem mass spectrometry (LC-MS/MS). The compounds included in the method were antineoplastics (cabazitaxel, docetaxel, doxorubicin, etoposide, irinotecan, methotrexate, paclitaxel, and topotecan), renin inhibitors (aliskiren), and antidepressants (maprotiline). The method was developed through several experiments on four online SPE cartridges, three reversed phase chromatography columns, and four combinations of mobile phase components. Under optimal conditions, very low limits of detection (LODs) of 1.30 to 10.6 ng L⁻¹ were obtained. The method was repeatable, with relative standard deviations (RSD, %) for intraday and interday precisions ranged from 1.6 to 7.8 and from 3.3 to 13.2, respectively. Recovery values ranged from 78.4 to 111.4%, indicating the reproducibility of the method. Matrix effects were mainly presented as signal suppression, with topotecan and doxorubicin being the two most affected compounds (31.0% signal suppression). The proposed method was successfully applied to hospital effluents, detecting methotrexate (4.7–9.3 ng L⁻¹) and maprotiline (11.2–23.1 ng L⁻¹). Due to the shorter overall run time of 15 min, including sample preparation, and reduced sample volume (0.9 mL), this on-line SPE-LC-MS/MS method was extremely convenient and efficient in comparison to the classical off-line SPE method. The proposed method was also highly sensitive and can be used for ultratrace quantification of the studied pharmaceuticals in wastewaters, providing useful data for effective environmental monitoring.

Irinotecan (CPT-11) is a water-soluble anticancer drug widely used to treat several types of cancer. Even if the metabolites of CPT-11 are well-known and investigated, only limited information is available in the literature about the formation of photo-degradation products that can naturally originate from sunlight irradiation when the drug is released in aqueous systems. CTP-11 solutions at 10.0 mg L-1 were irradiated by simulated sunlight. The intensity of the drug decreased by 90% after 7.5 days of irradiation and no significant reduction of absorbance values was observed after 13 days. A sensitive UHPLC-MS/MS method was developed employing a hybrid triple quadrupole/linear ion trap mass spectrometer, that is able to work in data-dependent acquisition mode and to obtain information about the compounds formed during the photoirradiation. Moreover, a selected reaction monitoring method was built using the MS/MS fragmentation pattern of the compounds previously investigated. The method was validated considering LOD, LOQ, linearity, precision, selectivity, recovery and matrix effect. LOD and LOQ values were 0.02 and 0.05 ng mL-1, respectively, whereas MDL and MQL values in real water samples (river water, groundwater, well water, and wastewater) were lower than 0.05 and 0.2 ng mL-1, respectively. Eight photodegradation products were identified, among which five for the first time. Based on the MS and MS/MS fragmentation, the chemical structures of the degradation products were proposed. Hydrolysis experiments were carried out on the same solutions preserved in the dark, but no formation of other species was highlighted. The method was applied to several real samples: CPT-11 was detected and quantified only in a hospital effluent sample at the concentration of 0.41 ± 0.2 ng mL-1 together with the occurrence of PDP3. The outcomes of this study may be useful for updating the pollutant screening in water samples.