Three dimensional braided composite materials exhibit better performance in terms of structural integrity, through-thickness strength and impact resistance, than laminated composites. Other advantages regarding production are the ability to produce composite structures with intricate geometries close to the near-net-shape, and also with continuous changes in its cross-section. These properties are a consequence of the internal geometry of the 3D braided composites, in which yarns are interlaced following specific patterns programmed on a braiding machine. In this article, the operation of a typical rotary braiding machine is emulated in order to automatically obtain the geometry of a braiding unit cell. Once the geometrical description is obtained, a finite element model has been developed in order to carry out virtual testing of 3D composite materials. An AS4/epoxy braided material system has been virtually tested and a theory-experimental correlation has been performed for the longitudinal modulus and yield strength compression, using a failure criterion based on constituents and interface failures.
This paper proposes an enhanced Cohesive Zone Model (CZM) for the prediction of delamination in curved beams of epoxy carbon laminates. This model improves the conventional CZM, taking into account the fiber-bridging phenomenon and the variation of the element size among the thickness in the curved zone. The advantages of the enhanced model are underlined when results obtained from the numerical simulations of a four-point-bending test in compliance with ASTM D6415 standard are compared with the corresponding experimental results. The prediction of the post-failure behavior obtained with this model is closer to that obtained experimentally than with the conventional model.
An iterative algorithm is proposed for determining the optimal chassis design of an electric vehicle, given a path and a reference time. The proposed algorithm balances the capacity of the battery pack and the dynamic properties of the chassis, seeking to optimize the tradeoff between the mass of the vehicle, its energy consumption, and the travel time. The design variables of the chassis include geometrical and inertial values, as well as the characteristics of the powertrain. The optimization is constrained by the slopes, curves, grip, and posted speeds of the different sections of the track. Particular service constraints are also considered, such as limiting accelerations due to passenger comfort or cargo safety. This methodology is applicable to any vehicle whose route and travel time are known in advance, such as delivery vehicles, buses, and race cars, and has been validated using telemetry data from an internal combustion rear-wheel drive race car designed for hill climb competitions. The implementation of the proposed methodology allows to reduce the weight of the battery pack by up to 20%, compared to traditional design methods.