Mostafa Geriesh

Dr. Mostafa Geriesh


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 June 2023 in Sensors
Verified
Journal Article
Open access
PDF file
MGMostafa Geriesh
Mostafa Geriesh
AEAhmed M. R. Fath El-Bab
Ahmed M. R. Fath El-Bab
WKWAEL MAHMOUD KHEIReldeen
WAEL MAHMOUD KHEIReldeen
HMHassan A. Mohamadien
Hassan A. Mohamadien
MHMohsen A. Hassan
Mohsen A. Hassan
Acceleration-based sensors are widely used in indicating the severity of damage caused to structural buildings during dynamic events. The force rate of change is of interest when investigating the effect of seismic waves on structural elements, and hence the calculation of the jerk is necessary. For most sensors, the technique used for measuring the jerk (m/s3) is based on differentiating the time–acceleration signal. However, this technique is prone to errors especially in small amplitude and low frequency signals, and is deemed not suitable when online feedback is required. Here, we show that direct measurement of the jerk can be achieved using a metal cantilever and a gyroscope. In addition, we focus on the development of the jerk sensor for seismic vibrations. The adopted methodology optimized the dimensions of an austenitic stainless steel cantilever and enhanced the performance in terms of sensitivity and the jerk measurable range. We found, after several analytical and FE analyses, that an L-35 cantilever model with dimensions 35 × 20 × 0.5 (mm3) and a natural frequency of 139 (Hz) has a remarkable performance for seismic measurements. Our theoretical and experimental results show that the L-35 jerk sensor has a constant sensitivity value of 0.05 ((deg/s)/(G/s)) with ±2% error in the seismic frequency bandwidth of 0.1~40 (Hz) and for amplitudes in between 0.1 and 2 (G). Furthermore, the theoretical and experimental calibration curves show linear trends with a high correlation factor of 0.99 and 0.98, respectively. These findings demonstrate the enhanced sensitivity of the jerk sensor, which surpasses previously reported sensitivities in the literature.

28 January 2024 in Journal of Nondestructive Evaluation
Verified
Journal Article
Open access
PDF file
MGMostafa Geriesh
Mostafa Geriesh
AEAhmed M. R. Fath El-Bab
Ahmed M. R. Fath El-Bab
HMHassan A. Mohamadien
Hassan A. Mohamadien
MHMohsen A. Hassan
Mohsen A. Hassan
The quality assessment of concrete material for new or existing buildings is critical to civil and structural engineers. In this scope, the development of nondestructive testing methods (NDT) has received significant attention and becomes essential for enhancing the on-site assessment of concrete performance. The Schmidt hammer (SH) test is one of the most widely used NDT for quantifying concrete strength. However, the reliability of this test and its accuracy are questioned by many researchers. In this study, the measurement quality of SH has been improved by attaching a developed cantilever-based jerk sensor to the SH mass. The theoretical model of the proposed measurement technique has been formulated and discussed. The experimental approach, jerk sensor design, SH body modification, electronic reading unit, testing, and construction of the calibration curves have been presented. Experimental results revealed that the accuracy of the developed SH has increased by 13% for concrete strength measurement, and the correlation coefficient of the strength calibration curve is 0.94. At the same time, the calibration curve of the concrete elasticity modulus showed a 0.93 correlation coefficient with 92% measurement accuracy. Analytical and experimental results have confirmed the applicability of the modified Schmidt hammer since it is reliable and more accurate compared to the traditional Schmidt Hammer.