Mohamed Genedi

Mr. Mohamed Genedi

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 February 2025 in Remote Sensing
Verified
Journal Article
Open access
PDF file
RSRagab A. El Sherbini
Ragab A. El Sherbini
Hosni H. GhazalaHosni H. Ghazala
Hosni H. Ghazala
MAMohammed Awad Ahmed
Mohammed Awad Ahmed
Ismael M. IbraheemIsmael M. Ibraheem
Ismael M. Ibraheem
HAHussain F. Al Ajmi
Hussain F. Al Ajmi
MGMohamed Genedi
Mohamed Genedi
Groundwater availability in semi-arid regions like the Widyan Basin, the Kingdom of Saudi Arabia (KSA), is a critical challenge due to climatic, topographic, and hydrological variations. The accurate identification of groundwater zones is essential for sustainable development. Therefore, this study combines remote-sensing datasets (Sentinel-2 and ASTER-DEM) with conventional data using Geographic Information System (GIS) and analytical hierarchy process (AHP) techniques to delineate groundwater potential zones (GWPZs). The basin’s geology includes Pre-Cambrian rock units of the Arabian Shield in the southwest and Cambrian–Ordovician units in the northeast, with the Saq Formation serving as the main groundwater aquifer. Six soil types were identified: Haplic and Calcic Yermosols, Calcaric Regosols, Cambic Arenosols, Orthic Solonchaks, and Lithosols. The topography varies from steep areas in the southwest and northwest to nearly flat terrain in the northeast. Hydrologically, the basin is divided into 28 sub-basins with four stream orders. Using GIS-based AHP and weighted overlay methods, the GWPZs were mapped, achieving a model consistency ratio of 0.0956. The zones were categorized as excellent (15.21%), good (40.85%), fair (43.94%), and poor (0%). The GWPZ model was validated by analyzing data from 48 water wells distributed in the study area. These wells range from fresh water to primary saline water, with water depths varying between 13.98 and 130 m. Nine wells—with an average total dissolved solids (TDS) value of 597.2 mg/L—fall within the excellent zone, twenty-one wells are categorized in the good zone, fifteen wells are classified in the fair zone, and the remaining wells fall into the poor zone, with TDS values reaching up to 2177 mg/L. The results indicate that the central zone of the study area is suitable for drilling new water wells.

23 February 2023 in Environmental Earth Sciences
Verified
Journal Article
Open access
PDF file
MGMohamed Genedi
Mohamed Genedi
Mohamed YoussefMohamed Youssef
Mohamed Youssef
There is an urgent need for greater water resources to support sustainable development in Ras Gara area of southwestern Sinai. Determining the water-bearing zones of the shallow Quaternary aquifer of the Araba Formation in the study region is therefore the main objective of the research. This will be done by using a variety of geophysical techniques, such as DC resistivity sounding and shallow seismic refraction surveys. Using the Schlumberger array (max. AB = 1200 m), the DC data were gathered at 27 VES locations along five primary profiles. At the same locations, 27 spreads totaling 115 m in length of seismic data were also performed. One-dimensional laterally constrained (1D-LCI) inversion is only applied to the DC data in order to generate a best-fit model, whereas 2D inversion is applied to other datasets. The area is divided up into five geo-electrical layers based on the results of 1D-LCI inversion of DC data, and the aquifer is classified into fresh (third layer) and saline bearing-zones (fourth layer). The resistivity values of the fresh-zone range from 8.7 to 26.7 Ω.m, with only low values (5–7.5 Ω.m) found at some VES sites, while the resistivity values of the saline-zone range between 0.9 and 3 Ω.m, except for (14.4 Ω.m) at VES-04. At depths of (2.4–15.6 m) and (8.7–28.5 m) for the fresh and saline zones, respectively. In this region, the shallow low resistive (about 10–100 Ω.m) and intermediate high conductive (< 10 Ω.m) layers of the 2D-DC inverted model represent the fresh and saline zones of the aquifer, respectively. The basement rocks were represented by a deep, extremely high resistive layer that can reach 40,000 Ω.m. Three subsurface layers are identified from the results of the 2D inversion of seismic data (VP1 = 400–1100 m.s−1, VP2 = 1200–1900 m.s−1 and VP3 = 2400–5400 m.s−1). The saturated zone of this aquifer is represented by the second layer (depth, 3.7–20.5 m). The basement rocks are also reflected in the last layer of high velocity. The inversion results and the previously available hydro-geological map data show a good degree of concordance. In the eastern portion of the study area, additional water wells could be drilled for additional water resources.

14 April 2025 in Scientific Reports
Verified
Journal Article
Open access
PDF file
MGMohamed Genedi
Mohamed Genedi
NGNoura Gouhar
Noura Gouhar
GEGAD EL-QADY
GAD EL-QADY
IGIbrahim Gaafar
Ibrahim Gaafar
AMAhmed El Sayed El Mahmoudi
Ahmed El Sayed El Mahmoudi
This study investigates the groundwater potential (GWP) in Wadi Diit, an arid region with promising resource development prospects, by integrating topographic, hydrogeological, and mineralogical parameters. To analyze the study area, a combination of conventional methods, remote sensing data from Sentinel-2, ASTER-GDEM, and ASTER-L1B, as well as DC resistivity datasets was utilized. The study region comprises Precambrian, Tertiary, and Quaternary surface rock units, supporting lithosol and Yermosol soil types. Barren lands dominate the landscape, while the southern portion experiences higher rainfall. Nine thematic layers (quartz index, carbonate index, slope, rainfall, drainage density, topographic wetness index, lineament density, land cover, and mafic index) were classified and weighted using GIS-based analytical hierarchy process, achieving a model accuracy of 0.0959. The GWP zones were categorized into very low (4.53%), low (17.33%), moderate (27.05%), high (27.79%), and very high (23.3%) categories, predominantly falling within moderate to very high classifications. Validation through hydrogeological data from 11 wells and a receiver operating characteristic curve analysis (area under curve = 0.8) confirmed the model’s reliability. DC resistivity measurements were conducted at nine vertical electrical sounding (VES) sites using a Schlumberger array (AB/2 = 500 m) along two profiles. The data were analyzed using various inversion techniques, including unconstrained 1D-VES, laterally constrained inversion (LCI-VES), spatially constrained inversion (SCI-VES), and 2D-VES inversions. A 0.3 constraint factor was applied to assess the accuracy of the model parameters, as their STDF derived from SCI-VES data were determined to be well-resolved. The SCI-VES and 2D-VES inversion results identified four distinct geological layers; unconsolidated surface deposits, gravelly-sand sediments of fresh-brackish Quaternary aquifer (30–384 Ω m and 3.7–15.9 m depth), saturated clayey-sand deposits, and saline Fractured Basement aquifer (10–137 Ω m and 33–90.4 m depth). The region exhibits a complex geological structure, characterized by an uplifted Fractured Basement aquifer trending southeast and southwest as indicated by 2D-VES models. The north-central region emerges as the most favorable location for substantial GWPZ, making it strategically ideal for the installation of additional water wells.


24 April 2024 in Environmental Earth Sciences
Verified
Journal Article
Open access
PDF file
MGMohamed Genedi
Mohamed Genedi
MAMohammed Awad Ahmed
Mohammed Awad Ahmed
The study area is situated in the Qelabshowah–Belqas region, known for its Quaternary deposits. This research aims to demonstrate the two-dimensional (2D) variation of subsurface layers and salinity distribution using geoelectrical data, hydrochemical analysis, and geostatistical analysis. DC resistivity measurements were taken at fifteen vertical electrical sounding (VES) survey points using a Schlumberger array (AB/2 = 100 m) along three profiles. In addition, an electrical resistivity tomography (ERT) survey was conducted with a dipole–dipole array across one profile. Seven surface water samples were collected in the area. From the 1D and 2D inversion of VES and ERT data sets, three-to-four geoelectric layers were identified, including unconsolidated surface deposits, saturated clayey sand, saturated sand, and a salt-rich layer. The 2D inversion of VES data revealed an ancient salt-rich layer deposited in swampy conditions over a conductive wet sand layer along profile one due to salt mineral infiltration and dissolution. The 2D inversion of ERT data showed accurate lateral geometric accuracy compared to the 2D inversion of VES data, highlighting geological features, such as caves in the second layer and a buried water canal on the ground surface. Surface water samples showed high salinity levels with sodium hazards, indicating an Na–Cl composition. Geoelectric and hydrochemical data sets were geostatistically analyzed using spherical variogram supported ordinary Kriging interpolation. The analysis indicated weak to moderate spatial dependency for true resistivity parameters, while sodium content (SC) and permeability index (PI) showed strong spatial correlation. The 2D spatial distribution resistivity maps based on the 1D inversion of VES data displayed a general decrease in resistivity with depth, likely due to clay minerals or moist soil in the second layer and saline irrigation water infiltration in the third layer. The 2D spatial distribution of SC and PI showed a high concentration zone, posing a potential risk to agricultural crops regardless of soil permeability. It is recommended to use these maps when cultivating plants that can tolerate high sodium levels during the reclamation process.

6 January 2026 in Acta Geophysica
Verified
Journal Article
Open access
PDF file
MGMohamed Genedi
Mohamed Genedi
MYMohamed A. S. Youssef
Mohamed A. S. Youssef
In semi-arid regions like Wadi El-Madamud, Egypt, sustainable groundwater management is hindered by the intricate interplay of structural, lithological, and climatic controls on aquifer recharge and storage. Despite the hydrogeological importance of the Plio-Pleistocene aquifer, integrated assessments for delineating groundwater potential zones (GWPZs) remain limited. This study bridges this gap through a multi-source, GIS-based approach combining conventional (geology, soil, rainfall), remote sensing (Sentinel-2 for LULC, Landsat 8–9 for NDVI, ASTER-GDEM for topography), and geophysical data (aeromagnetic and DC resistivity) within an analytic hierarchy process (AHP) framework. Ten thematic layers—geology, soil, slope, elevation, drainage density, lineament density, rainfall, topographic wetness index (TWI), LULC, and NDVI—were integrated using AHP-weighted overlay (consistency ratio = 0.05). The region’s stratigraphy spans Cretaceous to Holocene, with soils (Lithosols, Calcaric Fluvisols, Eutric Regosols, Calcic Yermosols) exhibiting differential infiltration and retention. GWPZ mapping classified the area into five categories: excellent (0.16%), good (25.54%), moderate (21.01%), fair (52.17%), and poor (1.12%), with high-potential zones localized along the Nile Valley fringe due to permeable Quaternary–Holocene sediments, Calcaric Fluvisols, and favorable topography. Model accuracy was validated using hydrochemical data from 15 wells, revealing a fresh to slightly saline gradient (TDS: 366–1541 mg/L), and ROC-AUC of 0.72. Aeromagnetic analysis identified dominant structural trends (N–S, E–W, NE–SW, NW–SE) and basement depths (100–1250 m), while DC resistivity (31 VES points, Schlumberger array, AB ≤ 1000 m) revealed a four-layer subsurface: consolidated wadi deposits (> 1000 Ω·m), saturated sand aquifer (≤ 100 Ω m, 25–85 m thick, 15–40 m depth), dry compacted sand (10 3 –10 4 Ω m), and Thebes Formation limestone (10 4 –10 5 Ω m). The study recommends cross-validation with MIF and Fuzzy AHP and prioritizes drilling in north-central, southwestern, and northeastern zones. By integrating surface and subsurface datasets, this work advances hydrogeological modeling in structurally complex terrains and provides a replicable framework for groundwater exploration in arid and semi-arid regions.