Shotcrete material has found extensive applications as a reinforcing material in the engineering sector. This study examined the effect of doped glass fibers on the mechanical performance of the modified shotcrete material composed of aeolian sand, fly ash, cement, quicklime, and doped glass fibers. Its tensile and shear strengths values were experimentally determined via a WAW-1000D computerized hydraulic universal tensile testing machine. Its microstructure was analyzed via a size analyzer, scanning electron microscope (SEM), and X-ray diffractometer (XRD). A 2D simplified mechanical model was elaborated to reflect the influence mechanism of the doped glass fibers on the mechanical performance of the modified shotcrete material. The experimental and mechanical analysis results indicated that, at the macroscopic scale, the experimental tensile and shear strengths of the shotcrete material doped with glass fibers were significantly higher than those of the undoped shotcrete material (by up to 310% and 596%, respectively). These results were in concert with the proposed model predictions, where the compound stresses in the shotcrete material were derived as the sum of the stress borne by the shotcrete material itself and the bridging stress exerted by the glass fibers. At the microscopic scale, SEM observations also revealed that the glass fibers were intertwined with each other and tightly enveloped by the shotcrete material particles within the modified shotcrete specimens, connecting the particles of different components into a whole and improving the overall mechanical strength. In addition, the relationships of the compound stress of the shotcrete material vs. embedment length, embedment angle, and cross-sectional area of the glass fibers were established. The research findings are considered instrumental in clarifying the mechanism by which the glass fibers influence the mechanical performance of shotcrete materials and optimize their solid waste (fly ash and quicklime) utilization.
7 February 2024 in Environmental Science and Pollution Research
Management of solid waste and protecting the ecological balance of the region are key challenges that the coal mining industry has to face. This study evaluated the effect of solid waste backfilling mining on the overlying strata movement and surface deformation variation pattern in slice mining. The mechanical characteristics of different cemented paste backfills (CPB) were compared. The CPB specimens were made of coal gangue and cement with or without the addition of fly ash. The experiments showed that the mechanical strength of the CPBs made of coal gangue and cement increased dramatically. A numerical simulation was then performed to analyze the variation patterns of the overlying strata displacement and surrounding rock stress distribution before and after filling the 3lower and 3upper coal seams with CPB. The CPBs reduced the movement of the surface by 95.1% and 95% during the mining of the 3lower and 3upper coal seams, respectively. Finally, we used a mining-induced subsidence prediction and analysis system to predict the influence of the 3lower and 3upper coal seams on the ground surface subsidence. It was found that the ground surface subsidence induced by CPB mining was 1/20 that of the cumulative ground surface subsidence caused by caving mining. CPB mining could effectively control the ground surface subsidence caused by multi-slice mining of the thick coal seam, offering protection for buildings above the ground. Our research provides theoretical and technical support for coal mining under buildings subjected to similar conditions.