Zinc oxide nanoparticles (ZnO NP) used for the channel region in inverted coplanar setup in Thin Film Transistors (TFT) were the focus of this study. The regions between the source electrode and the ZnO NP and the drain electrode were under investigation as they produce a Schottky barrier in metal-semiconductor interfaces. A more general Thermionic emission theory must be evaluated: one that considers both metal/semiconductor interfaces (MSM structures). Aluminum, gold, and nickel were used as metallization layers for source and drain electrodes. An organic-inorganic nanocomposite was used as a gate dielectric. The TFTs transfer and output characteristics curves were extracted, and a numerical computational program was used for fitting the data; hence information about Schottky Barrier Height (SBH) and ideality factors for each TFT could be estimated. The nickel metallization appears with the lowest SBH among the metals investigated. For this metal and for higher drain-to-source voltages, the SBH tended to converge to some value around 0.3 eV. The developed fitting method showed good fitting accuracy even when the metallization produced different SBH in each metal-semiconductor interface, as was the case for gold metallization. The Schottky effect is also present and was studied when the drain-to-source voltages and/or the gate voltage were increased.
26 October 2015 in Semiconductor Science and Technology
Ni/TiO2/4H-SiC diodes were analysed through measurements of current–voltage curves varying the temperature. The Schottky Barrier Height (SBH) which increased with temperature was studied by simulation of the Thermionic Emission Model, considering Ni/SiC Schottky structures with an insulator layer between the metal and semiconductor. This model shows that a new method of calculation should be applied to diodes that have a metal–insulator–semiconductor structure. Misleading results for SBH are obtained if the thin insulator layer is not considered. When applying the suggested method to the Ni/TiO2/4H-SiC diodes it was necessary to consider not only the deposited TiO2 layer, but also a second dielectric layer of native SiCxOy at the surface of SiC. By measuring I–V–T curves for two samples with different thicknesses of TiO2, the suggested method allows one to estimate the thicknesses of both dielectric layers: TiO2 and SiOxCy.
1 February 2012 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
Schottky Barrier Height (SBH) of Metal-Insulator-Semiconductor Ni/SiC diodes were theoretically and experimentally analysed through simulation/measurements of Current-Voltage curves. The SBH increase with the temperature was studied by Thermionic Emission Model, considering an insulator layer between metal and semiconductor. A new method of simulation is described, showing that extracting the SBH without taking into account the existence of the insulating layer, provides misleading results for Schottky diodes with Metal Insulator Semiconductor structure. The difference between real SBH and apparent SBH is discussed. An explanation for the SBH apparent increasing when the measuring temperature is increased is suggested. As an example the model is applied on fabricated Ni/SiC Schottky structures.