The chapter topic “Understanding Adsorption: Theories, Techniques, and Applications” will provide a comprehensive exploration of the fundamental theories, experimental techniques, and practical applications of adsorption processes. It will begin by discussing the foundational theories that explain adsorption behaviour, including physisorption and chemisorption, and their underlying molecular interactions. Key adsorption models, such as Langmuir, Freundlich and BET isotherms, will be reviewed to offer insights into adsorption dynamics, capacity and surface interactions. The chapter will also cover various experimental techniques used to characterise adsorption, such as gravimetric methods, gas adsorption analysis and calorimetry, which help determine the properties of adsorbents and adsorbates. Furthermore, the chapter will examine real-world applications of adsorption in diverse fields, including environmental engineering for water and air purification, gas separation, catalysis and energy storage systems. The potential of advanced adsorbent materials, such as porous materials and nanostructures, will be discussed in light of emerging challenges and technological advancements. This chapter aims to equip readers with both theoretical knowledge and practical insights into the wide-ranging applications of adsorption processes.

In the present work, magnesium oxide (MgO) and lead oxide (PbO) nanoparticles were prepared by the co-precipitation method. Their structural parameters and morphology were investigated using XRD, HRTEM, and FTIR. The formation of the phases was seen to have small average crystallite sizes and an orthorhombic crystal structure for both MgO and PbO nanoparticles. The results of HR-TEM showed irregularly shaped nanoparticles: quasi-spherical or rod-like shapes and spherical-like shapes for MgO and PbO nanoparticles, respectively. The produced nanoparticles’ size using X-ray diffraction analysis was found to be 17 nm and 41 nm for MgO and PbO nanoparticles, respectively. On the other hand, it was observed from the calculations that the optical band gap obeys an indirect allowed transition. The calculated values of the band gap were 4.52 and 4.28 eV for MgO and PbO NPs, respectively. The MB was extracted from the wastewater using the prepared composites via absorption. Using a variety of kinetic models, the adsorptions were examined. Out of all the particles, it was discovered that the composites were best. Furthermore, of the models currently under consideration, the pseudo-second-order model best fit the degradation mechanism. The resultant composites could be beneficial for degrading specific organic dyes for water purification, as well as applications needing a wider optical band gap.

Zinc sulfide (ZnS) nanoparticles were fabricated using the chemical precipitation method. The X-ray diffraction (XRD), Raman spectroscopy, and scanning electron microscopy (SEM) techniques were used to investigate the structural parameters of the formed ZnS. The hexagonal crystal structure of the Zn and ZnS phases was formed. The average crystallite size of the ZnS phase is 10.3 nm, which is much smaller than that of the Zn phase (54.5 nm). Several frequencies and phonon modes were detected in the Raman scattering spectrum belonging to the ZnS nanoparticles. The synthesized ZnS nanoparticles were used as catalysts to eliminate the Congo red (CR) dye, with different concentrations, from synthetic wastewater. The impact of the CR dye concentration and shaking period on the adsorption of CR was thoroughly investigated, and various adsorption kinetic models were tested. After 3 h of shaking, the adsorption efficiency reached 26.01% for 40 mg/L CR dye and 27.84% for 20 mg/L CR dye. The adsorption capacities of the CR dye in the presence of ZnS are 16% and 9% for 40 and 20 mg/L, respectively. Based on the correlation factor, the intraparticle diffusion kinetic model was considered the best of the tested models.