Gökçen Bombar

Dr. Gökçen Bombar


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 March 2021 in Water
Verified
Journal Article
Open access
PDF file
JBJoana Baltazar
Joana Baltazar
Elsa AlvesElsa Alves
Elsa Alves
Gökçen BombarGökçen Bombar
Gökçen Bombar
ACAntónio Heleno Cardoso
António Heleno Cardoso
This laboratory study focused on the effect of a submerged vane-field on the flow pattern and bed morphology near and inside the entrance reach of a movable bed 90° lateral diversion. The system was modelled under live bed conditions for a water discharge ratio of ≈0.2. Two experiments were run until bed equilibrium was reached: with and without a vane-field installed close to the diversion entrance to control the transfer of sediments into the diversion channel. The equilibrium bed morphology and the associated 3D flow field were measured in great detail. The bed load diverted into the diversion was reduced by approximately one quarter due to the action of the vane-field. The vanes prevented the formation of the diversion vortex in the main channel, upstream of the diversion’s entrance, thus contributing to that decrease. They also created a main channel vortex that started at the most upstream vanes and further decreased the amount of bed load entering the diversion. The flow separation zone inside the diversion was larger with vanes, but conveyance was balanced through a slightly deeper scour trench therein. The flow structures described were confirmed through the measurements of the turbulent kinetic energy.

27 November 2019 in Iranian Journal of Science and Technology, Transactions of Civil Engineering
Verified
Journal Article
Closed access
PDF file
Gökçen BombarGökçen Bombar
Gökçen Bombar

1 November 2023 in Turkish Journal of Civil Engineering
Verified
Journal Article
Open access
PDF file
Gökçen BombarGökçen Bombar
Gökçen Bombar
AAAysegul Ozgenc Aksoy
Aysegul Ozgenc Aksoy
MGMehmet Şükrü Güney
Mehmet Şükrü Güney
The grain size distribution of the transported bed load was experimentally investigated under unsteady flow conditions with bimodal mixture of sand and gravel in a laboratory flume. Five various triangular hydrographs were generated. A clockwise behavior for the total bed load versus shear velocity was observed meaning that the bed load during rising limb was higher than that of falling limb. It was found that the percent finer at the plateau of bimodal sediment size distribution curve had higher values during the initial and final phases compared to those obtained during the peak time. At all plateaus, the percent finer values related to the hydrograph peak discharge were in the same order of magnitude with that of the bed material. The sand content of the transported bed material initially decreased, then maintained a constant value during a certain time interval and finally returned to its original value. The sand percent of the bed load decreased in the falling limb showing a counterclockwise loop and the duration of the hydrograph did not affect the results considerably. The greater the peak flow rate of the hydrograph, the greater was the hysteresis. The bimodality index was calculated for all transported sediment samples and it was revealed that its initial and final values were less than that of the bed material but it was approximately the same elsewhere. The 5% finer sediment amount was nearly equal during rising and falling limbs. It was revealed that D50 value of the bed load decreased in the rising limb showing a clockwise loop. The hysteresis was not considerably changed according to the hydrograph characteristics. The clockwise type hysteresis was also observed for the size group of D95. The lag increased as the peak flow rate increased. A strong relation was found between the dimensionless total bed load Wt* and the total work index Wk as well as Wk and the ratio WR/WF. The correlations between the dimensionless total bed load and the unsteadiness parameters P, and Pmod were very weak, whereas a high value of determination coefficient was obtained with the unsteadiness parameter Pgt, implying an appreciable interdependence.

24 August 2022 in Journal of Innovative Science and Engineering
Verified
Journal Article
Open access
PDF file
Gökçen BombarGökçen Bombar
Gökçen Bombar
It is reported that every year hundreds of bridges collapse due to the dynamic forces acting on the piers, particularly during floods and the scour around the foundations. Since the determination of the velocity distribution upstream of the pier is directly related to this force, it is important to predict the effect of a presence and diameter of a bridge pier on velocity and turbulence parameters. In this study, the time variation of point velocities in the stream-wise and vertical direction at a point upstream of a bridge pier was obtained under clear-water and unsteady flow conditions. The presence of the bridge pier causes the velocity profile to be steeper. The increase in pier diameter decreased the maximum stream-wise velocity whereas it increased the vertical velocity in the down flow direction particularly near the bed. The turbulence intensity in stream-wise direction increases in the rising limb and decreases in the falling limb, more prominently near the bottom. The maximum percent reductions in the stream-wise velocities at peak flow were calculated as 6% and 11% for the small and big piers, respectively. The reduction in stream-wise velocity at peak flow increases with depth especially for the pier with greater diameter

1 September 2024
Verified
Conference Paper
Closed access
ZBZehra Büyüker
Zehra Büyüker
Gökçen BombarGökçen Bombar
Gökçen Bombar
ACAntónio Heleno Cardoso
António Heleno Cardoso
River confluences are locations where two or more rivers merge and continue to flow as a single stream. At a confluence, hydrodynamics, sediment transport processes, and morpho-dynamics influence and modify each other. The flow structure of the confluence zone interacts with the sediment transport, which results in bed morphology changes. In this study, two experiments were carried out in the large-scale open channel confluence of İzmir Kâtip Çelebi University Hydraulics Laboratory, where two symmetrical tributaries forming a right-angle lead to a main channel. While the flow rate from each tributary was equal and 20 l/s for both experiments, the sediment loads were set as 0 kg/min in both tributaries in one experiment and 0.1 kg/min in both tributaries in the other one. The flow depth at the downstream of the confluence was adjusted to be 5.0 cm on top of a 20.0 cm deep sand layer on the bed. The bed topography and the water surface were measured at the end of the experiments (t = 15 h) by using the distance measurement feature of a Vectrino probe and three ULS-40D probes, respectively. The results of the experiment where sand was supplied to the tributaries essentially confirmed the morphological model of mobile bed confluences reported in the literature as applying to asymmetrical confluences (including two tributary mouth bars, two bank-attached bars, one central scour hole and one mid main-channel bar), whereas the clear-water experiment only complied with some results of a limited number of previous equivalent studies.

4 January 2025 in Acta Geophysica
Verified
Journal Article
Closed access
PDF file
Gökçen BombarGökçen Bombar
Gökçen Bombar
ACAntónio Heleno Cardoso
António Heleno Cardoso