The lower Vistula River was regulated in the years 1856–1878, at a distance of 718–939 km. The regulation plan did not take into consideration the large transport of the bed load. The channel was shaped using simplified geometry—too wide for the low flow and overly straight for the stabilization of the sandbar movement. The hydraulic parameters of the lower Vistula River show high velocities of flow and high shear stress. The movement of the alternate sandbars can be traced on the optical satellite images of Sentinel-2. In this study, a method of sandbar detection through the remote sensing indices, Sentinel Water Mask (SWM) and Automated Water Extraction Index no shadow (AWEInsh), and the manual delineation with visual interpretation (MD) was used on satellite images of the lower Vistula River, recorded at the time of low flows (20 August 2015, 4 September 2016, 30 July 2017, 20 September 2018, and 29 August 2019). The comparison of 32 alternate sandbar areas obtained by SWM, AWEInsh, and MD manual delineation methods on the Sentinel-2 images, recorded on 20 August 2015, was performed by the statistical analysis of the interclass correlation coefficient (ICC). The distance of the shift in the analyzed time intervals between the image registration dates depends on the value of the mean discharge (MQ). The period from 30 July 2017 to 20 September 2018 was wet (MQ = 1140 m3 × s−1) and created conditions for the largest average distance of the alternate sandbar shift, from 509 to 548 m. The velocity of movement, calculated as an average shift for one day, was between 1.2 and 1.3 m × day−1. The smallest shift of alternate sandbars was characteristic of the low flow period from 20 August 2015 to 4 September 2016 (MQ = 306 m3 × s−1), from 279 to 310 m, with an average velocity from 0.7 to 0.8 m × day−1.
The amount of sediments transported by a river is difficult to estimate, while this parameter could influence channel geometry. It is possible to derive the bedload transport rate per unit width of the river channel by measuring the migration distance of bedform profiles over time and thickness of bedload layer in motion. Other possible methods include instrumental measurements using bedload traps and empirical formulas. It is possible to use remote-sensing techniques to measure the dynamics of bedform movements and geometries. Landsat images and aerial photographs have been used for this. A new source of remote-sensing information is radar satellite images. Sentinel-1 images have a temporal resolution of 2–3 days and spatial resolution of 25 m at middle latitudes, which make them usable on large rivers. The research area is the 814–820 km reach of the Lower Vistula River, where seven alternate sandbars were selected. The bank lines of the sandbars were delineated on Sentinel-1 images sensed during two low-flow periods of 4 August–26 September 2018 and 1 July–31 August 2019, when discharges at low flow were similar. From water stage observations at gauges, water elevations were assigned to every bank line of the alternate sandbars. The following morphometric parameters were calculated: alternate sandbar centers, volumes and longitudinal profile. Average daily movement of the sandbars in the period 4 August 2018–1 July 2019 was calculated as 0.97 m·day−1. A similar alternate sandbar movement velocity was obtained from a study of Sentinel-2 optical satellite images and hydro-acoustic measurements on the Lower Vistula River. Having depth of bedload in motion and alternate sandbar shift velocities, it was possible to calculate the rate of bedload transport according to the Exner approach formula. Rate of bedload transport was estimated as qb = 0.027 kg·s−1·m−1. This study shows a novel use of Sentinel-1 images to study the 3D geometry and movement rate of sandbars.
This paper introduces the Sandbar Detector plugin for Quantum Geographic Information System (QGIS), designed to streamline the detection and analysis of riverbed forms, previously hindered by time-consuming manual methods requiring extensive expertise in remote sensing and Geographic Information System (GIS). The Sandbar Detector plugin, developed in Python, leverages the Sentinel Water Mask (SWM), a reliable remote sensing water index, for precise differentiation between water and land. By integrating SWM with QGIS, the plugin utilises high-resolution data from Sentinel-2 satellites, offering a robust tool for environmental analysis. • Automation of detection: The plugin automates detecting riverbed forms, enhancing data analysis efficiency and consistency. • User-friendly interface: It makes the plugin accessible to users without advanced remote sensing and GIS knowledge. • High-resolution data: The plugin uses Sentinel-2 satellite data, ensuring precise and reliable results.
30 June 2020 in Acta Scientiarum Polonorum. Formatio Circumiectus
Cel pracy: Opracowanie i przetestowanie metody detekcji form korytowych na wybranym odcinku dolnej Wisły. Do przeprowadzenia badań wykorzystano archiwalne, powszechnie dostępne obrazy satelitarne Sentinel-2. Problemem badawczym jest optymalizacja narzędzi, danych retrospektywnych oraz...
The amount of sediments transported by a river is very difficult to estimate, however this parameter has an important influence on channel geometry. It is possible to estimate the bedload transport rate per unit width of a river channel by measuring bedform profiles’ migration distance (Δl) in time (Δt) and depth of bedload in motion (hb). Another method is instrumental measurements using bedload traps and empirical formulas. Sentinel-1 images at mid latitudes have a temporal resolution of 2–3 days and spatial resolution of 25 m, which allows them to be used on large rivers. The research area in this paper is the Lower Vistula River from km 814 to km 820, where seven alternate sandbars were selected. The coast lines of the sandbars were delineated on Sentinel-1 images taken during two low flow periods 2018.08.04–09.26 and 2019.07.01–08.31 with similar discharges at low flow phase on the hydrograph. From water stage observations at the Chełmno and Grudziądz gauge stations, water elevations were assigned to every coast line of the alternate sandbars. The centers, volumes and longitudinal profile of the alternate sandbars were calculated. Average daily movement of the sandbars in the period 2018.08.04–2019.07.01 was calculated as 0.97 m·day˗1. Similar alternate sandbar movement velocities were obtained from a study of Sentinel-2 optical satellite images and hydro-acoustic measurements on the Lower Vistula River. Having the height of the alternate sandbars and velocity of movement, it was possible to calculate the rate of the bedload transport as qb = 5 kg·s˗1·m˗1. This value is similar to results of empirical formulas accepted for use on large lowland rivers in Poland: Goncarov – 5 kg·s˗1·m˗1, Samov – 3 kg·s˗1·m˗1; Meyer-Peter and Müller – 9 kg·s˗1·m˗1; Skibiński (1976) – 15 kg·s˗1·m˗1. The novelty of this research is showing the use of Sentinel-1 images for the study of river channel dynamics and calculation of bedload transport.