The lower Vistula River was regulated in the years 1856–1878, at a distance of 718–939 km. The regulation plan did not take into consideration the large transport of the bed load. The channel was shaped using simplified geometry—too wide for the low flow and overly straight for the stabilization of the sandbar movement. The hydraulic parameters of the lower Vistula River show high velocities of flow and high shear stress. The movement of the alternate sandbars can be traced on the optical satellite images of Sentinel-2. In this study, a method of sandbar detection through the remote sensing indices, Sentinel Water Mask (SWM) and Automated Water Extraction Index no shadow (AWEInsh), and the manual delineation with visual interpretation (MD) was used on satellite images of the lower Vistula River, recorded at the time of low flows (20 August 2015, 4 September 2016, 30 July 2017, 20 September 2018, and 29 August 2019). The comparison of 32 alternate sandbar areas obtained by SWM, AWEInsh, and MD manual delineation methods on the Sentinel-2 images, recorded on 20 August 2015, was performed by the statistical analysis of the interclass correlation coefficient (ICC). The distance of the shift in the analyzed time intervals between the image registration dates depends on the value of the mean discharge (MQ). The period from 30 July 2017 to 20 September 2018 was wet (MQ = 1140 m3 × s−1) and created conditions for the largest average distance of the alternate sandbar shift, from 509 to 548 m. The velocity of movement, calculated as an average shift for one day, was between 1.2 and 1.3 m × day−1. The smallest shift of alternate sandbars was characteristic of the low flow period from 20 August 2015 to 4 September 2016 (MQ = 306 m3 × s−1), from 279 to 310 m, with an average velocity from 0.7 to 0.8 m × day−1.
The amount of sediments transported by a river is difficult to estimate, while this parameter could influence channel geometry. It is possible to derive the bedload transport rate per unit width of the river channel by measuring the migration distance of bedform profiles over time and thickness of bedload layer in motion. Other possible methods include instrumental measurements using bedload traps and empirical formulas. It is possible to use remote-sensing techniques to measure the dynamics of bedform movements and geometries. Landsat images and aerial photographs have been used for this. A new source of remote-sensing information is radar satellite images. Sentinel-1 images have a temporal resolution of 2–3 days and spatial resolution of 25 m at middle latitudes, which make them usable on large rivers. The research area is the 814–820 km reach of the Lower Vistula River, where seven alternate sandbars were selected. The bank lines of the sandbars were delineated on Sentinel-1 images sensed during two low-flow periods of 4 August–26 September 2018 and 1 July–31 August 2019, when discharges at low flow were similar. From water stage observations at gauges, water elevations were assigned to every bank line of the alternate sandbars. The following morphometric parameters were calculated: alternate sandbar centers, volumes and longitudinal profile. Average daily movement of the sandbars in the period 4 August 2018–1 July 2019 was calculated as 0.97 m·day−1. A similar alternate sandbar movement velocity was obtained from a study of Sentinel-2 optical satellite images and hydro-acoustic measurements on the Lower Vistula River. Having depth of bedload in motion and alternate sandbar shift velocities, it was possible to calculate the rate of bedload transport according to the Exner approach formula. Rate of bedload transport was estimated as qb = 0.027 kg·s−1·m−1. This study shows a novel use of Sentinel-1 images to study the 3D geometry and movement rate of sandbars.
This research focuses on the use of HySpex hyperspectral images for verification of two-dimensional hydrodynamic modelling of open-channel flow over loose bed (CCHE2D) and assessment of water quality in the Zegrze Reservoir. The CCHE2D hydrodynamic model results show the distribution of hydraulic parameters of water flow and the sediment concentrations in the reservoir. HySpex images were used to obtain remote sensing indices of water quality. The images were compared to the hydrodynamic model results and field measurements. The analysis of hydrodynamic model results and hyperspectral image indices show the spatial distribution of the water’s physico-chemical properties in the reservoir, and poor mixing of the Bug River and the Narew River at their confluence. This study shows that there is synergy potential in using hydrodynamic modelling results and remote sensing indices of water quality for analysis of the reservoir’s water quality.
30 June 2020 in Acta Scientiarum Polonorum. Formatio Circumiectus
Cel pracy: Opracowanie i przetestowanie metody detekcji form korytowych na wybranym odcinku dolnej Wisły. Do przeprowadzenia badań wykorzystano archiwalne, powszechnie dostępne obrazy satelitarne Sentinel-2. Problemem badawczym jest optymalizacja narzędzi, danych retrospektywnych oraz...
In this paper, the Pilica River catchment (central Poland) is analyzed with a focus on understanding the total phosphorous transfer along the river system which also contains the large artificial Sulejów Reservoir. The paper presents a GIS method for estimating the total phosphorous (TP) load from proxy data representing sub-catchment land use and census data. The modelled load of TP is compared to the actual transfer of TP in the Pilica River system. The results shows that the metrics of connectivity between river system and dwelling areas as well as settlement density in the sub-catchments are useful predictors of the total phosphorous load. The presence of a large reservoir in the middle course of the river can disrupt nutrient transport along a river continuum by trapping and retaining suspended sediment and its associated TP load. Analysis of the indirect estimation of TP loads with the GIS analysis can be useful for identifying beneficial reservoir locations in a catchment. The study has shown that the Sulejów Reservoir has been located in a subcatchment with a largest load of the TP, and this feature helps determine the problem of reservoir eutrphication