A diagnostic survey on the precast prestressed bridge Nižná confirmed significant deterioration due to environmental distress. Evidently, decisive failures of the structure have a similar character as in the previous precast prestressed bridge in Podbiel in the northern part of Slovakia. These failures result from the unsuitable concept of the first generation of precast prestressed concrete beams, which was used in the former Czechoslovakia in the second half of the 20th century. Subsequently, experimental verification using the proof-load test was also executed. This bridge was built in 1956, so at the time of testing, it was 60 years old. The paper presents the indirect determination of prestressing level in one precast post-tensioned concrete beam using the saw-cut method. Experimental measurement was executed during the bridge demolition. Subsequently, a 2D numerical model in ATENA 2D Software, with the assumption of nonlinear material behavior for verification of experimental results, was performed. Finally, the residual prestressing force was evaluated and compared with the expected state of prestressing according to Eurocodes after 60 years of service.

Structures and bridges are being designed on the proposed and requested design lifetime of 50 to 100 years. In practice, one can see that the real lifetime of structures and bridges is shorter in many cases, in some special cases extremely shorter. The reasons for the lifetime shortening can be increased of the load cases (e.g., due to traffic on bridges, or due to other uses of a structure), using the material of lower quality, implementation of new standards and codes according to Eurocode replacing older ones. During the whole lifetime the structures must be maintained to fulfil the code requests. If the constructions are not able to fulfil the Ultimate Limit States (ULS) and the Serviceability Limit State (SLS), the structures or bridges have to be strengthened (whole or its elements). The purpose of the paper is the presentation of using a layer of the fibre concrete for a columns’ strengthening. Using the fibre reinforced concrete (FRC) of higher tensile strength makes it possible to increase the load-bearing capacity of the cross-section the column. The contact between the old concrete (core of column) and newly added layer (around column) is very important for using that method of strengthening. In the article, there is also a comparison of the surface modification methods.

The optimisation of the design method for verification of slender steel beam-columns is still a current issue not only from scientific point of view, but also for design practice. Therefore, the main objective of this paper is comparison of the suitability of established design approaches, according to the European standards for steel and aluminium structures, on the basis of numerical simulations. Thus, a finite element model was validated on the basis of experimental analysis available in the scientific literature. To perform the comparison of accuracy of design approaches according to European standards, a commercial software program ANSYS was used for observation of the resistances of beam-columns. The resistance of european I beams with parallel flanges (IPE) and a rectangular hollow cross-section (RHS) were investigated for four load cases on a simply supported member and also on a pinned-fixed beam column with linear bending moment distribution, where the resistance of the cross-section governs. Finally, the conclusions for suitability of the respective design approaches are discussed, together with some findings that arose from this work.

Modern construction requirements for building structures are currently focused on reducing the time required for construction, dealing with the lack of qualified human resources and ensuring comprehensive construction work quality. The problems mentioned above of today’s construction industry are significantly reduced by modern prefabrication and the efficient use of the most common building materials—steel and concrete. Critical components of such construction systems are their joints. Currently, there are many different types of joints of precast concrete structural elements. Integral parts of these joints are the various anchorages. For connecting load-bearing components, cast-in-place anchor systems are preferred to post-installed ones. The appropriate design of this small but crucial structural component is a complicated engineering issue in some cases. The finite element method (FEM) represents a practical opportunity to design and analyze anchorage systems in detail. A detailed numerical study based on an experimental program was performed to understand cast-in-place anchors’ real behavior and clarify some of the parameters of their design. This paper explains the creation of a numerical model, compares the FEM model with the performed experiments and presents the interesting results of the performed parametric study.