This work is focused on the valorization of brewer’s spent grains (BSG) into volatile fatty acids (VFA) through acidogenic fermentation. VFAs are building blocks for several applications, such as bioplastics’ production. Using acid hydrolysis as pre-treatment, several batch assays were performed and the impact of organic load (OL) and pH on VFA production from BSG hydrolysate was assessed. Regardless of the condition, the produced acids were mainly butyric and acetic acids followed by propionic acid. The OL had a direct impact on the total organic acid concentration with higher concentrations at the highest OL (40 gCOD L−1). pH affected the concentration of individual organic acid, with the highest fermentation products (FP) diversity attained at pH 5.0 and OL of 40 gCOD L−1. To assess the potential application of organic acids for biopolymers (such as polyhydroxyalkanoates) production, the content in hydroxybutyrate (HB) and hydroxyvalerate (HV) monomers was estimated from the respective precursors produced at each pH and OL. The content in HV precursors increased with pH, with a maximum at pH 6.0 (ca. 16% C-mol basis). The acidogenic fermentation of BSG hydrolysate was also assessed in continuous operation, using an expanded granular sludge bed reactor (EGSB). It was shown that the BSG hydrolysate was successfully converted to VFAs without pH control, achieving higher productivities than in the batch operation mode.
Raw brewers’ spent grain (BSG), a by-product of beer production and produced at a large scale, presents a composition that has been shown to have potential as feedstock for several biological processes, such as polyhydroxyalkanoates (PHAs) production. Although the high interest in the PHA production from waste, the bioconversion of BSG into PHA using microbial mixed cultures (MMC) has not yet been explored. This study explored the feasibility to produce PHA from BSG through the enrichment of a mixed microbial culture in PHA-storing organisms. The increase in organic loading rate (OLR) was shown to have only a slight influence on the process performance, although a high selectivity in PHA-storing microorganisms accumulation was reached. The culture was enriched on various PHA-storing microorganisms, such as bacteria belonging to the Meganema, Carnobacterium, Leucobacter, and Paracocccus genera. The enrichment process led to specialization of the microbiome, but the high diversity in PHA-storing microorganisms could have contributed to the process stability and efficiency, allowing for achieving a maximum PHA content of 35.2 ± 5.5 wt.% (VSS basis) and a yield of 0.61 ± 0.09 CmmolPHA/CmmolVFA in the accumulation assays. Overall, the production of PHA from fermented BSG is a feasible process confirming the valorization potential of the feedstock through the production of added-value products.
Bioplastics are a sustainable and environmental-friendly alternative to the conventional petroleum-based plastics, namely due to their source (biobased) and due to their biodegradability or both. Polyhydroxyalkanoates (PHA) stand out among the bioplastics group by being intracellular biobased, biodegradable and biocompatible polymers. PHA production has been highly investigated during the last decades. However, to date, PHA production has been monitored through offline and time-consuming tools, involving hazardous solvents, not allowing a timely control of the bioprocesses, which often results in a loss of process productivity and hinders its implementation at full scale. Therefore, two-dimensional (2D) fluorescence spectroscopy was assessed for monitoring the PHA content at real-time, as it is a non-destructive, solvent-free and non-invasive technique. The complex information of the biological broth was captured within fluorescence excitation-emission matrices (EEMs), which were deconvoluted through projection to latent structures (PLS) modelling to estimate PHA production by an enriched PHA microbial culture, using fermented brewer's spent grain as feedstock. A good correlation for PHA prediction was achieved, with an average error of ca. 4.0% gPHA/gTS for new predictions. This work demonstrates the great potential of using 2D fluorescence spectroscopy to assess the intracellular PHA content without requiring staining agents. Moreover, it unlocks the possibility of an online and real-time monitoring of the biopolymer production processes, which will contribute towards the improvement of the PHA process productivity and, consequently, its implementation at full scale.