This paper presents the design of a small size Unmanned Aerial Vehicle (UAV) using the 3DEXPERIENCE software. The process of designing the frame parts involves many methods to ensure the parts can meet the requirements while conforming to safety and industry standards. The design steps start with the selection of materials that can be used for the drone, which are polylactic acid (PLA), acrylonitrile styrene acrylate (ASA), and acrylonitrile butadiene styrene (ABS). The drone frame consists of four main parts, which are the center top cover (50 g), the side top cover (10 g), the middle cover (30 g), and the drone’s arm (80 g). A simulation was carried out to determine the stress, displacement, and weight of the drone’s parts. Additionally, a trade-off study was conducted to finalize the shapes of the parts and the various inputs based on their priorities. The outcome of this new design can be represented in design concepts, which involve the use of the snap hook function to assemble two body parts together, namely the middle cover and the center top cover, without the need of an additional fastener.
Recent research has shown an increasing interest in wireless power transfer (WPT) technology for drone batteries. The inconvenience of wired charging, especially for drones, is a huge obstacle. In this research project, a WPT platform was proposed by applying four transmitting coils and a single receiving coil. To meet the industrial standards required for transmitter Tx and receiver Rx, a calculation of the parameters was implemented. An H-bridge MOSFET was used as a DC–AC inverter, a bridge diode was used as an AC–DC rectifier, and a Pi low pass filter was added to the receiver circuit design to filter the high-frequency noise. Experimental investigations were conducted to study the maximum power and power efficiency of the coil’s alignment. The focus of this article was to design and fabricate workable multiple-transmitter coils and a single-receiver coil for a wireless power transfer system, in order to charge a 3S LiPo drone’s battery. It not only covers an overview of wireless power transfer but also includes the method for charging a 3S LiPo drone’s battery, a misalignment study on the X and Y axes of the wireless charging system, and a stable charging of the battery that does not exceed the maximum current of 1.26 A for healthy charging. An efficiency of 58.29% was achieved at a power of 14.924 W and the minimum value was found to be 0.008 W. The efficiency of the typical coil design and the proposed coil design were 55.04% and 12.06%, respectively. The charging current obtained was 1.27 A, which gives an estimated charging time of 3.31 h based on the calculation. The actual charging time of the 3s 4200 mAh 11.1 V LiPo battery was 2 h.