Microalgae have been shown to be a source of multiple bio-based products ranging from high value molecules to commodities. Along with their potential to produce a large variety of products, microalgae can also be used for the depollution of wastewaters of different origins (urban, industrial, and agricultural). This paper is focused on the importance of harnessing the bioremediation capacity of microalgae to treat wastewaters in order to develop the microalgae industry (especially the microalgae biofuel industry) and to find other alternatives to the classic wastewater treatment processes. The current research on the potential of microalgae to treat a specific wastewater or a targeted pollutant is reviewed and discussed. Then, both strategies of selecting the best microalgae strain to treat a specific wastewater or pollutant and using a natural or an artificial consortium to perform the treatment will be detailed. The process options for treating wastewaters using microalgae will be discussed up to the final valorization of the biomass. The last part is dedicated to the challenges which research need to address in order to develop the potential of microalgae to treat wastewaters.

Arthrospira platensis (Spirulina) is the most cultivated microalga worldwide. Improving its cultivation in terms of biomass productivity, quality, or production cost could significantly impact the Spirulina industry. The objectives of this paper were defined as to contribute to this goal. Spirulina biomass productivity was investigated through medium choice. A modified Zarrouk’s medium was selected as it gave higher final dry weights and longer sustained growth than Hiri’s and Jourdan’s media. Then, in order to reduce Spirulina production cost, modified Zarrouk’s medium was rationalized by testing different dilutions. It was found that modified Zarrouk’s medium could be diluted up to five times without impacting the growth rates in a 28-days batch cultivation. Higher dry weights were even observed after 21 days of batch cultivation (1.21 g/L for 20%-modified Zarrouk’s medium in comparison to 0.84 g/L for modified Zarrouk’s medium). Iron uptake was then investigated as one of the major contributors to Spirulina nutritional quality. An increase in iron content was obtained by replacing iron sulfate by iron EDTA at a concentration of 10 mg_Fe/L (2.11 ± 0.13 mg_Fe/g_biomass for EDTA-FeNa, 3 H₂O at 10 mg_Fe/L compared to 0.18 ± 0.13 for FeSO₄,6H₂O at 2 mg_Fe/L). Impact of light intensity on Spirulina biomass productivity was also investigated in a 2 L Photobioreactor (PBR). Specific growth rates were calculated for Photosynthetically Photon Flux Densities (PPFD) from 85 to 430 µmol/m²/s. At 430 µmol/m²/s, photoinhibition was not observed and the specific growth rate was maximum (0.12/day). Finally, a 40-day cultivation experiment was conducted in a 1000 L PBR giving a maximum daily areal productivity of 58.4 g/m²/day. A techno-economic analysis gave production cost two to 20 times higher for PBR (from 18.71 to 74.29 €/kg) than for open ponds (from 3.86 to 9.59 €/kg) depending on Spirulina productivity.