Rosangela Moreno

Dr. Rosangela Moreno


Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 June 2016
Verified
Conference Paper
Closed access
PAP. M. Adrian
P. M. Adrian
RMRosangela Moreno
Rosangela Moreno
Well testing data is usually affected by different wellbore effects. Phase redistribution is one of the most important in gas wells with high liquid production (condensate or water) and volatile oil wells. The longer the wellbore phenomena, the higher the probability to distort reservoir pressure behavior (infinite acting flow regime, linear flow, etc.). In this situation, the conventional pressure transient analysis would be hard to perform, increasing the probability to obtain erroneous values of permeability and skin factor. Nevertheless, in the last years, the use of primary and secondary pressure derivative as a diagnostic plots (Semilog and Log-Log plots), demonstrated to be very useful in low permeability gas wells and weak phase redistribution gas wells. This paper evaluates of the second semilog pressure derivative technique for different types of phase redistribution. It also presents the application of this diagnostic plot in the interpretation of two gas-condensate well test with strong phase redistribution phenomena. Results highlight the applicability of second semilog pressure derivative over other similar techniques.

29 July 2020 in Nanomaterials
Verified
Journal Article
Open access
PDF file
Rueda EdgarRueda Edgar
Rueda Edgar
SASalem Akarri
Salem Akarri
Ole TorsaeterOle Torsaeter
Ole Torsaeter
RMRosangela Moreno
Rosangela Moreno
Recently, the combination of conventional chemical methods for enhanced oil recovery (EOR) and nanotechnology has received lots of attention. This experimental study explores the dynamic changes in the oil configuration due to the addition of nanoparticles (NPs) to biopolymer flooding. The tests were performed in water-wet micromodels using Xanthan Gum and Scleroglucan, and silica-based NPs in a secondary mode. The microfluidic setup was integrated with a microscope to capture the micro-scale fluid configurations. The change in saturation, connectivity, and cluster size distributions of the non-wetting phase was evaluated by means of image analysis. The biopolymer content did not affect the ability of the NPs to reduce the interfacial tension. The experiments showed that the reference nanofluid (NF) flood led to the highest ultimate oil recovery, compared to the Xanthan Gum, Scleroglucan and brine flooding at the same capillary number. In the cases of adding NPs to the biopolymer solutions, NPs-assisted Xanthan flooding achieved the highest ultimate oil recovery. This behavior was also evident at a higher capillary number. The overall finding suggests a more homogenous dispersion of the NPs in the solution and a reduction in the polymer adsorption in the Xanthan Gum/NPs solution, which explains the improvement in the sweep efficiency and recovery factor.

1 January 2022 in Journal of Petroleum Science and Engineering
Verified
Journal Article
Closed access
FPFuat Campos Pereira
Fuat Campos Pereira
KCKarl Jan Clinckspoor
Karl Jan Clinckspoor
RMRosangela Moreno
Rosangela Moreno

30 June 2021 in Ct&f - Ciencia, Tecnología Y Futuro
Verified
Journal Article
Open access
PDF file
KCKarl Jan Clinckspoor
Karl Jan Clinckspoor
VFVitor Hugo de Sousa Ferreira
Vitor Hugo de Sousa Ferreira
RMRosangela Moreno
Rosangela Moreno
Enhanced oil recovery (EOR) techniques are essential to improve oil production, and polymer flooding has become one of the promising technologies for the Brazilian Pre-Salt scenario. Biopolymers offer a range of advantages considering the Pre-Salt conditions compared to synthetic polymers, such as resistance to high salinity, high temperature, and mechanical degradation. In that sense, bulk rheology is the first step in a workflow for performance analysis. This paper presents a rheological analysis of four biopolymers (Schizophyllan, Scleroglucan, Guar Gum, and Xanthan Gum) in concentrations from 10 to 2,300 ppm, generally suitable for EOR applications, in temperature levels of 25, 40, 50, 60 and 70°C and two brines of 30,100 ppm and 69,100 ppm total dissolved solids, which aim to model seawater and the mixture between injected seawater and reservoir water typical in Pre-Salt conditions. The pseudoplastic behavior, the overlap concentration, and the activation energy were determined for each polymer solution. The structural differences in the polymers resulted in different rheological behaviors. Schizophyllan is the most promising, as its viscosifying power is higher than synthetic polymers comparable to Xanthan Gum. Its resistance at high temperatures is higher than that of synthetic polymers. Scleroglucan behaved similarly to Xanthan Gum, with the added advantage of being nonionic. Guar Gum had the lowest viscosities, highest overlap concentrations, and most pronounced viscosity decay among the tested polymers. To the author’s knowledge, rheological studies of the biopolymers presented here, considering the viscosities and the overlap concentration and activation energy, in the Pre-salt conditions, are not available in the literature and this will benefit future works that depend on this information

11 September 2020 in Oil & Gas Science and Technology – Revue d’IFP Energies nouvelles
Verified
Journal Article
Open access
VFVitor H.S. Ferreira
Vitor H.S. Ferreira
RMRosangela Moreno
Rosangela Moreno
Injection of polymers is beneficial for Enhanced Oil Recovery (EOR) because it improves the mobility ratio between the displaced oil and the displacing injected water. Because of that benefit, polymer flooding improves sweep and displacing efficiencies when compared to waterflooding. Due to these advantages, polymer flooding has many successful applications in sandstone reservoirs. However, polymer flooding through carbonatic rock formations is challenging because of heterogeneity, high anionic polymer retention, low matrix permeability, and hardness of the formation water. The scleroglucan is a nonionic biopolymer with the potential to overcome some of those challenges, albeit its elevated price. Thus, the objective of this work is to characterize low concentration scleroglucan solutions focusing on EOR for offshore carbonate reservoirs. The laboratory evaluation consisted of rheology, filtration, and core flooding studies, using high salinity multi-ionic brines and light mineral oil. The tests were run at 60 °C, and Indiana limestone was used as a surrogate reservoir rock. A rheological evaluation was done in a rotational rheometer aiming to select a target polymer concentration for the injection fluid. Different filtration procedures were performed using membrane filters to prepare the polymer solution for the displacement process. Core flooding studies were done to characterize the polymer solution and evaluate its oil recovery relative to waterflooding. The polymer was characterized for its retention, inaccessible pore volume, resistance factor,in-situviscosity, and permeability reduction. Rheology studies for various polymer concentrations indicated a target scleroglucan concentration of 500 ppm for the injection solution. Among the tested filtration methods, the best results were achieved when a multi-stage filtration was performed after an aging period of 24 h at 90 °C temperature. The single-phase core flooding experiment resulted in low polymer retention (20.8 μg/g), inaccessible pore volume (4.4%), and permeability reduction (between 1.7 and 2.4). The polymer solutionin-situviscosity was slightly lower and less shear-thinning than the bulk one. The tested polymer solution was able to enhance the oil recovery relative to waterflooding, even with a small reduction of the mobility ratio (38% relative reduction). The observed advantages consisted of water phase breakthrough delay (172% relative delay), oil recovery anticipation (159% and 10% relative increase at displacing fluid breakthrough and 95% water cut, respectively), ultimate oil recovery increase (6.3%), and water-oil ratio reduction (38% relative decrease at 95% water cut). Our results indicate that the usage of low concentration scleroglucan solutions is promising for EOR in offshore carbonate reservoirs. That was supported mainly by the low polymer retention, injected solution viscosity maintenance under harsh conditions, and oil recovery anticipation.

28 March 2020 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
Verified
Journal Article
Closed access
PDF file
MZM. F. Zampieri
M. F. Zampieri
VFV. H. S. Ferreira
V. H. S. Ferreira
CQC. C. Quispe
C. C. Quispe
KSK. K. M. Sanches
K. K. M. Sanches
RMRosangela Moreno
Rosangela Moreno