The main objective of the S-STEP (the Small Synthetic Aperture Radar (SAR) Technology Experimental Project (S-STEP)) mission is developing an 80-kg-class active X-band SAR observation small satellite. For lighter, smaller, better, and cheaper development of the S-STEP system, a new thermal design strategy is essential. Therefore, we proposed a new thermal design strategy in this study. The main features of the proposed thermal design involve the minimization of heater power consumption by optimizing environmental heat fluxes on the satellite, the provision of long-term SAR imaging duration in both right- and left-looking modes, and the use of a lightweight flexible graphite sheet as a thermal interface for some high-power instruments. These features contribute to minimizing the satellite’s mass budget through heater power minimization and achieving on-orbit system performance of S-STEP. The effectiveness of the proposed thermal design was numerically verified by on-orbit thermal analysis of the S-STEP system. In addition, the thermal design on a key payload component and the multifunctional transmit/receive module structure were verified through a space-simulated thermal vacuum test.
The structural safety of solar cells mounted on deployable solar panels in the launch vibration environment is a significant aspect of a successful CubeSat mission. This paper presents a novel highly damped deployable solar panel module that is effective in ensuring structural protection of solar cells under the launch environment by rapidly suppressing the vibrations transmitting through the solar panel by constrained layer damping achieved using printed circuit board (PCB)-based multilayered thin stiffeners with double-sided viscoelastic tapes. A high-damping solar panel demonstration model with a three-pogo pin-based burn wire release mechanism was fabricated and tested for application in the 6U CubeSat “STEP Cube Lab-II” developed by Chosun University, South Korea. The reliable release function and radiation hardness assurance of the mechanism in an in-orbit environment were confirmed by performing solar panel deployment tests and radiation tests, respectively. The design effectiveness and structural safety of the proposed solar panel module were validated by launch vibration and in-orbit environment tests at the qualification level.
In this study, we analyzed the imaging maneuver time, retargeting maneuver time, and attitude maneuvering characteristics in the imaging section (Phase 1) and retargeting maneuver section (Phase 2) when taking multiple-target images in squint spotlight mode in a single pass of a passive SAR satellite. In particular, the synthetic aperture time and attitude maneuvering characteristics in the staring and sliding spotlight modes that can image the wider swath width while maintaining high resolution were compared and analyzed. In the sliding spotlight mode, the rotation center was located below the ground surface when the satellite was maneuvering towards the target. Steering and sliding maneuvers were performed when targeting, and the synthetic aperture time of the sliding spotlight was longer than that of the staring spotlight because overlapping imaging was performed on the point target. The satellite maneuvering during imaging can be considered as a time-fixed problem, because it was performed within synthetic aperture time according to resolution, incidence angle, swath width, etc., by minimizing the Doppler centroid variation. In order to optimize the retargeting maneuver time, an optimal analysis of the attitude maneuvering was carried out and the validity of the optimal analysis algorithm was confirmed. Finally, the scenario was analyzed by assuming a problem of imaging four targets with 5 × 5 km swath width in a 20 km × 20 km densely populated area. It was confirmed that if a squint angle of ±12 degrees is provided in a single pass, four high resolution images of 5 km × 5 km can be imaged in the sliding spotlight mode.
30 November 2021 in Journal of Space Technology and Applications
우주기술과 응용(Journal of Space Technology and Applications; J. Space Technol. Appl. 이하 JSTA )은 한국의 우주과학 및 우주 응용 분야에서 가장 권위 있는 학술단체인 한국우주과학회에서 Journal of Astronomy and Space Sciences 와 더불어 발행되고 있는 공식적인 정기 간행물이다. JSTA 는 2021년 5월 창간호를 시작으로 연 4회 분기별로 발간되고 있으며, JSTA 의 논문과 기고문 은 한국어 또는 영어로 게재 가능하며, 각 논문과 기고문에는 고유의 DOI가 부여된다. JSTA 에 게재 되는 모든 논문과 기고문은 Open Access 정책에 따라 JSTA 홈페이지(https://www.jstna.org)를 통해 누구나 전문을 무료로 열람할 수 있다.