This paper describes the main concept and development of a standard platform architecture of 3U Cube Satellite, whose design and performance were implemented and verified through the development of KAUSAT-5 3U CubeSat. The 3U standard platform is built in 1.5U size and developed as a modular concept to add and expand payloads and attitude control actuators to meet the user’s needs. In the case of the electrical power system, the solar panel, the battery, and the deployment mechanism are designed to be configured by the user. Mechanical system design maximizes the electrical capability to accommodate various payloads and to integrate and miniaturize EEE (Electrical, Electronic, and Electromechanical) parts and subsystem functions/performance into limited-size PCBs. The performance of KAUSAT-5 adopting standard platform was verified by mounting the VSCMG (Variable Speed Control Moment Gyro), which is one payload for technical demonstration, at the bottom of the platform and the infrared (IR) camera, which is the other payload for science mission, on the top. The 3U CubeSat equipped with the electronic optical camera is under development implementing the standard platform to reduce development cost and schedule by minimizing additional verification.
The digital sun sensor calculates the incident sunlight angle using the sunlight image registered on a CMOS image sensor. In order to accomplish this, an exact center of the sunlight image has to be determined. Therefore, an accurate estimate of the centroid is the most important factor in digital sun sensor development. The most general method for determining the centroid is the thresholding method, and this method is also the simplest and easy to implement. Another centering algorithm often used is the image filtering method that utilizes image processing. The sun sensor accuracy using these methods, however, is quite susceptible to noise in the detected sunlight intensity. This is especially true in the thresholding method where the accuracy changes according to the threshold level. In this paper, a template method that uses the sunlight image model to determine the centroid of the sunlight image is suggested, and the performance has been compared and analyzed. The template method suggested, unlike the thresholding and image filtering method, has comparatively higher accuracy. In addition, it has the advantage of having consistent level of accuracy regardless of the noise level, which results in a higher reliability.
In this study, we analyzed the imaging maneuver time, retargeting maneuver time, and attitude maneuvering characteristics in the imaging section (Phase 1) and retargeting maneuver section (Phase 2) when taking multiple-target images in squint spotlight mode in a single pass of a passive SAR satellite. In particular, the synthetic aperture time and attitude maneuvering characteristics in the staring and sliding spotlight modes that can image the wider swath width while maintaining high resolution were compared and analyzed. In the sliding spotlight mode, the rotation center was located below the ground surface when the satellite was maneuvering towards the target. Steering and sliding maneuvers were performed when targeting, and the synthetic aperture time of the sliding spotlight was longer than that of the staring spotlight because overlapping imaging was performed on the point target. The satellite maneuvering during imaging can be considered as a time-fixed problem, because it was performed within synthetic aperture time according to resolution, incidence angle, swath width, etc., by minimizing the Doppler centroid variation. In order to optimize the retargeting maneuver time, an optimal analysis of the attitude maneuvering was carried out and the validity of the optimal analysis algorithm was confirmed. Finally, the scenario was analyzed by assuming a problem of imaging four targets with 5 × 5 km swath width in a 20 km × 20 km densely populated area. It was confirmed that if a squint angle of ±12 degrees is provided in a single pass, four high resolution images of 5 km × 5 km can be imaged in the sliding spotlight mode.
1 December 2008 in Sensors and Actuators A: Physical