The Burstein-Moss shift and band gap narrowing of sputtered indium-doped zinc oxide (IZO) thin films are investigated as a function of carrier concentrations. The optical band gap shifts below the carrier concentration of 5.61 × 1019 cm-3 are well-described by the Burstein-Moss model. For carrier concentrations higher than 8.71 × 1019 cm-3 the shift decreases, indicating that band gap narrowing mechanisms are increasingly significant and are competing with the Burstein-Moss effect. The incorporation of In causes the resistivity to decrease three orders of magnitude. As the mean-free path of carriers is less than the crystallite size, the resistivity is probably affected by ionized impurities as well as defect scattering mechanisms, but not grain boundary scattering. The c lattice constant as well as film stress is observed to increase in stages with increasing carrier concentration. The asymmetric XPS Zn 2p3/2 peak in the film with the highest carrier concentration of 7.02 × 1020 cm-3 suggests the presence of stacking defects in the ZnO lattice. The Raman peak at 274 cm-1 is attributed to lattice defects introduced by In dopants.
25 August 2021 in ACS Applied Materials & Interfaces
Preferred orientation of ZnO thin films deposited by the atomic layer deposition (ALD) technique could be manipulated by deposition temperature. In this work, diethyl zinc (DEZn) and deionized water (H(2)O) were used as a zinc source and oxygen source, respectively. The results demonstrated that (10.0) dominant ZnO thin films were grown in the temperature range of 155-220 °C. The c-axis crystal growth of these films was greatly suppressed. Adhesion of anions (such as fragments of an ethyl group) on the (00.2) polar surface of the ZnO thin film was believed to be responsible for this suppression. In contrast, (00.2) dominant ZnO thin films were obtained between 220 and 300 °C. The preferred orientations of (10.0) and (00.2) of the ZnO thin films were examined by XRD texture analysis. The texture analysis results agreed well with the alignments of ZnO nanowires (NWs) which were grown from these ZnO thin films. In this case, the nanosized crystals of ZnO thin films acted as seeds for the growth of ZnO nanowires (NWs) by chemical vapor deposition (CVD) process. The highly (00.2) textured ZnO thin films deposited at high temperatures, such as 280 °C, contained polycrystals with the c axis perpendicular to the substrate surface and provided a good template for the growth of vertically aligned ZnO NWs.
13 January 2020 in Environmental Science and Pollution Research
Effluent discharges from industry and domestic waste containing unknown inorganic pollutants. In this work, different mechanisms of heavy metal ions removal using ZnO particles were studied. ZnO particles were synthesized using solid precipitation technique. The morphology of ZnO particles was rod-like shape. The average length and diameter of ZnO particle were 497.34 ± 15.55 and 75.78 ± 10.39nm, respectively. These particles removed effectively heavy metal ions such as Cu(II), Ag(I) and Pb(II) ions with efficiency >85% under exposure of 1 hour of UV light. However, poor removal efficiency, i.e. <15% was observed for Cr(VI), Mn(II), Cd(II) and Ni(II) ions. The removal of these heavy metal ions was in the forms of metals or metal oxide via reduction/oxidation or adsorption mechanism.
Vertically aligned ZnO nanowires (NWs) with a length of 1.5–10 μm and a mean diameter of ca. 150 nm were grown by chemical vapour deposition onto a c-oriented ZnO seed layer which was deposited by atomic layer deposition on Si substrates. The substrates were then spin-coated with an ethanol solution containing Pd nanoparticles with an average size of 2.7 and 4.5 nm. A homogeneous distribution of the Pd nanoparticles on ZnO NWs has been obtained using both Pd particle series. The catalytic activity of the ZnO NWs and Pd/ZnO NWs catalysts was measured in the semihydrogenation of 2-methyl-3-butyn-2-ol at 303-343 K and a pressure of 2–10 bar. The effect of the solvent used on the catalytic performance of the Pd/ZnO NWs catalyst was studied. The Pd/ZnO catalysts showed alkene selectivity of up to 95% at an alkyne conversion of 99%. A kinetic model is proposed to explain the activity and selectivity of the ZnO support and Pd/ZnO catalysts.
About Me
School of Materials and Mineral Resources Engineering, Universiti Sains Malaysia
School of Materials and Mineral Resources Engineering, Universiti Sains Malaysia