In addition to chloride induced corrosion, the other commonly occurring type of rebar corrosion in reinforced concrete structures is that induced by the ingress of atmospheric carbon dioxide into concrete, commonly referred to as ‘carbonation induced corrosion’. This paper presents a new approach for detecting the onset and quantifying the level of carbonation induced rebar corrosion. The approach is based on the changes in the mechanical impedance parameters acquired using the electro-mechanical coupling of a piezoelectric lead zirconate titanate (PZT) ceramic patch bonded to the surface of the rebar. The approach is non-destructive and is demonstrated though accelerated tests on reinforced concrete specimens subjected to controlled carbon dioxide exposure for a period spanning over 230 days. The equivalent stiffness parameter, extracted from the frequency response of the admittance signatures of the PZT patch, is found to increase with penetration of carbon dioxide inside the surface and the consequent carbonation, an observation that is correlated with phenolphthalein staining. After the onset of rebar corrosion, the equivalent stiffness parameter exhibited a reduction in magnitude over time, providing a clear indication of the occurrence of corrosion and the results are correlated with scanning electron microscope images and Raman spectroscopy measurements. The average rate of corrosion is determined using the equivalent mass parameter. The use of PZT ceramic transducers, therefore, provides an alternate and effective technique for diagnosis of carbonation induced rebar corrosion initiation and progression in reinforced concrete structures non-destructively

A stepwise approach has been applied for the cosensitization of a thiocyanate free Ru sensitizer (SPS-01) with a metal free dye containing thienylfluorene conjugation (JD1) for dye sensitized solar cells (DSSCs). The cosensitized SPS-01 + JD1 based DSSC showed a significant enhancement in both the open circuit voltage (V_oc) and the short circuit current (J_sc) relative to the individual single dye based DSSCs. The DSSC based on the SPS-01 + JD1 system yielded a J_sc of 15.38 mA cm⁻², a V_oc of 0.72 V, a fill factor (FF) of 0.76 and a power conversion efficiency (PCE) of 8.30%. This performance was superior to that of the DSSCs sensitized with the individual dyes SPS-01 (PCE = 5.98%) or JD1 (PCE = 4.76%) fabricated under the same conditions. Results show that the JD1 dye effectively overcomes the competitive light absorption by I₃ ⁻/I⁻ and also prevents dye aggregation and reduces the charge recombination. To understand the effects of the charge recombination of the injected electrons with I₃ ⁻ in the electrolyte, the dark current–voltage characteristics and electrochemical impedance spectra of the DSSCs sensitized with the SPS-01 and SPS-01+JD1 systems were measured. It was observed that the recombination of the electrons in the conduction band with I₃ ⁻ in the electrolyte in the DSSC sensitized with SPS-01 +JD1 was significantly reduced relative to the DSSC based on SPS-01.