A bainite/martensite multiphase rail is treated by the controlled-cooling process with different finish-cooling temperatures. The simulated temperature–time curves of the position of 5 mm and 15 mm below the rail tread (P5 and P15) express different trends. P5 has greater impact toughness and lower tensile strength than P15. Microstructural characterization was carried out by conducting scanning electron microscopy, X-ray diffraction, electron backscatter diffraction, and transmission electron microscopy. The greater tensile strength is due to the dispersed ε-carbides hindering the movement of dislocations. The greater impact toughness is attributed to the filmy retained austenite and the smaller effective grain with high-angle boundary. Finite element modeling (FEM) and microstructural characterization reasonably explain the changes of mechanical properties. The present work provides experimental and theoretical guidance for the development of rail with excellent mechanical properties.
5 March 2019 in Heat Treatment and Surface Engineering
A novel isothermal bainitic transformation combined with quenching and partitioning (i.e. ‘disturbed’ bainitic austempering) process was employed in an Mn–Si–Cr–C low-alloyed steel to reduce the fraction and size of the blocky martensite/austenite (M/A) islands; the M/A islands that are inevitably formed during the conventional bainitic austempering process are coarse and undesirable for property optimization. Owing to a novel heat treatment, an enhanced combination of strength and ductility was achieved (e.g. ultimate strength, ∼1445 MPa; total elongation, ∼28%). A pronounced TRIP effect of the refined retained austenite contributes a lot to the overall improvement.
In this paper, we have studied the influence of deformation on the microstructure and mechanical properties of 20Mn2SiCrNi bainitic high strength steel processed through a hot rolling route. Simulation of different temperatures and degrees of deformation was carried out via Gleeble-1500. The study suggested that grain size is refined when the deformation is carried out at lower temperature (> Ac3). When the degree of deformation was increased from 20% to 60%, grain size and microstructure were both refined and the size of retained austenite was reduced. The tensile strength increased from 1345 MPa to 1432 MPa. The impact toughness increased from 115 J/cm2 to 210 J/cm2 at room temperature, from 63 J/cm2 to 142 J/cm2 at −40 °C. Furthermore, it was observed that the microstructure after air cooling was composed of granular bainite (GB), lath bainite (LB) and martensite/austenite (MA) island for different deformation conditions. The study reveals that the impact toughness of 20Mn2SiCrNi bainitic high strength steel can be increased by increasing the degree of deformation.