Applications of abundant seawater in electrochemical energy conversion are constrained due to the sluggish oxygen evolution reaction and the corrosive chlorine oxidation reaction. Hence, it is imperative to develop an efficient anodic reaction alternative suitable for coupling with the cathodic counterpart. Due to a low thermodynamic oxidation potential, hydrazine oxidation reaction (HzOR) offers a unique pathway to overcome these challenges. Herein, spontaneously in situ reduced atomic scale Pd surface‐confined to electrochemically prepared layered Co(OH)2 on carbon cloth is synthesized. This study reveals the hydrazine and Pd‐dependent morphological evolution of Co(OH)2 and its Pd hybrids into nanoparticulate form. Unlike various layered double hydroxides, Pd integrated Co(OH)2 benefits from the contribution of Co(OH)2 as an active HzOR catalyst and the reductive support to host Pd, resulting in synergistically improved performances. Mass activities of Pd in alkaline and alkaline saline electrolyte are 11.24 and 9.83 A mgPd−1 at 200 mV, respectively, corresponding to the highest HzOR activities among noble metals. The optimized Pd hybrid demonstrates ≈6.5 times the current density relative to PtC (14.91 mA cm−2 at 200 mV) in alkaline saline water with hydrazine. These findings would be beneficial to realize high overpotential anodic alternatives and reduce over‐dependence on freshwater for electrocatalysis.
Solar hydrogen production using photoelectrochemical (PEC) cells requires the selection of cost‐effective materials with high photoactivity and durability. CuBi 2 O 4 photocathodes possess an appropriate bandgap for efficient hydrogen production. However, their performance is limited by poor charge transport and interface voids formed due to the porous structure during annealing, which complicates the deposition of passivation overlayers. To address this, effective suppression of the porous structure in CuBi 2 O 4 is essential. Here, the study proposes the strategic use of an Sb‐Cu 2 O buffer layer with a uniform (111) crystal orientation prior to the electrodeposition of Cu‐Bi‐O. This buffer layer facilitates 2D film growth during electrodeposition, enhancing Cu supply via out‐diffusion from the buffer during annealing. Moreover, the uniform orientation of the buffer layer promotes the crystallization of CuBi 2 O 4 , significantly improving charge transport efficiency. By incorporating an Al‐ZnO/TiO 2 overlayer, the study achieves a photocurrent of 2.56 mA cm −2 at 0 V RHE and an onset potential of 1.04 V RHE , with excellent stability exceeding 60 hours. In a glycerol oxidation reaction coupled with hydrogen production, an unassisted PEC cell with a BiVO 4 photoanode demonstrates the highest H 2 production (750.5 µmol cm −2 ) among Cu‐based ternary oxides, with 97% Faradaic efficiency over 20 hours while producing DHA, and formic acid.
An effective strategy for improving the charge transport efficiency of p-type Cu2O photocathodes is the use of counter n-type semiconductors with a proper band alignment, preferably using Al-doped ZnO (AZO). Atomic layer deposition (ALD)-prepared AZO films show an increase in the built-in potential at the Cu2O/AZO interface as well as an excellent conformal coating with a thin thickness on irregular Cu2O. Considering the thin thickness of the AZO overlayers, it is expected that the composition of the Al and the layer stacking sequence in the ALD process will significantly influence the charge transport behavior and the photoelectrochemical (PEC) performance. We designed various stacking orders of AZO overlayers where the stacking layers consisted of Al2O3 (or Al) and ZnO using the atomically controlled ALD process. Al doping in ZnO results in a wide bandgap and does not degrade the absorption efficiency of Cu2O. The best PEC performance was obtained for the sample with an AZO overlayer containing conductive Al layers in the bottom and top regions. The Cu2O/AZO/TiO2/Pt photoelectrode with this overlayer exhibits an open circuit potential of 0.63 V and maintains a high cathodic photocurrent value of approximately −3.2 mA cm−2 at 0 VRHE for over 100 min.
Pt‐based electrocatalysts for glycerol oxidation reaction (GOR) exhibit low durability due to the inactivation of Pt through rapid poisoning under oxidative conditions. Thus, bimetallic PtBi was strategically synthesized using BiOI as a photoactive intermediate for the uniform photoelectrodeposition of Pt. The nanostructured Pt–Bi was electrochemically reduced from a Pt/BiOI medium, and the GOR‐activated Pt–Bi electrocatalysts (G–Pt–Bi) were obtained via a subsequent electrochemical activation process. Here, abundant Bi sites in PtBi can prevent Pt poisoning and effectively provide adsorbed OH− for the GOR on Pt sites. Consequently, it allows the operation in low onset potential for GOR with a high mass activity of 13.35 A mgPt−1 at 0.85 VRHE in alkaline solution. The GOR products obtained using G–Pt–Bi were identified as glycolate and formate by 1H‐nuclear magnetic resonance without the interruption of the hydrogen evolution reaction, and it finally enables the operation of a membrane‐free two‐electrode system. In situ electrochemical impedance spectroscopy demonstrates that the G–Pt–Bi exhibit superior GOR kinetics and higher resistance to Pt inactivation compared with conventional Pt/C. This study suggests a novel design for a G–Pt–Bi architecture in developing durable and high‐mass‐activity Pt catalysts for the GOR. image
9 January 2023 in Energy & Environmental Materials
Rh has been widely studied as a catalyst for the promising hydrazine oxidation reaction that can replace oxygen evolution reactions for boosting hydrogen production from hydrazine‐containing wastewater. Despite Rh being expensive, only a few studies have examined its electrocatalytic mass activity. Herein, surface‐limited cation exchange and electrochemical activation processes are designed to remarkably enhance the mass activity of Rh. Rh atoms were readily replaced at the Ni sites on the surface of NiOOH electrodes by cation exchange, and the resulting RhOOH compounds were activated by the electrochemical reduction process. The cation exchange‐derived Rh catalysts exhibited particle sizes not exceeding 2 nm without agglomeration, indicating a decrease in the number of inactive inner Rh atoms. Consequently, an improved mass activity of 30 A mgRh−1 was achieved at 0.4 V versus reversible hydrogen electrode. Furthermore, the two‐electrode system employing the same CE‐derived Rh electrodes achieved overall hydrazine splitting over 36 h at a stable low voltage. The proposed surface‐limited CE process is an effective method for reducing inactive atoms of expensive noble metal catalysts.