A representative method of forming CuO thin films on Cu2O photoabsorbers is simple annealing oxidation at high temperature in a controlled oxygen atmosphere, but the typical oxidation process is irregular, resulting in a high density of defect sites.
Applications of abundant seawater in electrochemical energy conversion are constrained due to the sluggish oxygen evolution reaction and the corrosive chlorine oxidation reaction. Hence, it is imperative to develop an efficient anodic reaction alternative suitable for coupling with the cathodic counterpart. Due to a low thermodynamic oxidation potential, hydrazine oxidation reaction (HzOR) offers a unique pathway to overcome these challenges. Herein, spontaneously in situ reduced atomic scale Pd surface‐confined to electrochemically prepared layered Co(OH)2 on carbon cloth is synthesized. This study reveals the hydrazine and Pd‐dependent morphological evolution of Co(OH)2 and its Pd hybrids into nanoparticulate form. Unlike various layered double hydroxides, Pd integrated Co(OH)2 benefits from the contribution of Co(OH)2 as an active HzOR catalyst and the reductive support to host Pd, resulting in synergistically improved performances. Mass activities of Pd in alkaline and alkaline saline electrolyte are 11.24 and 9.83 A mgPd−1 at 200 mV, respectively, corresponding to the highest HzOR activities among noble metals. The optimized Pd hybrid demonstrates ≈6.5 times the current density relative to PtC (14.91 mA cm−2 at 200 mV) in alkaline saline water with hydrazine. These findings would be beneficial to realize high overpotential anodic alternatives and reduce over‐dependence on freshwater for electrocatalysis.
Solar hydrogen production using photoelectrochemical (PEC) cells requires the selection of cost‐effective materials with high photoactivity and durability. CuBi 2 O 4 photocathodes possess an appropriate bandgap for efficient hydrogen production. However, their performance is limited by poor charge transport and interface voids formed due to the porous structure during annealing, which complicates the deposition of passivation overlayers. To address this, effective suppression of the porous structure in CuBi 2 O 4 is essential. Here, the study proposes the strategic use of an Sb‐Cu 2 O buffer layer with a uniform (111) crystal orientation prior to the electrodeposition of Cu‐Bi‐O. This buffer layer facilitates 2D film growth during electrodeposition, enhancing Cu supply via out‐diffusion from the buffer during annealing. Moreover, the uniform orientation of the buffer layer promotes the crystallization of CuBi 2 O 4 , significantly improving charge transport efficiency. By incorporating an Al‐ZnO/TiO 2 overlayer, the study achieves a photocurrent of 2.56 mA cm −2 at 0 V RHE and an onset potential of 1.04 V RHE , with excellent stability exceeding 60 hours. In a glycerol oxidation reaction coupled with hydrogen production, an unassisted PEC cell with a BiVO 4 photoanode demonstrates the highest H 2 production (750.5 µmol cm −2 ) among Cu‐based ternary oxides, with 97% Faradaic efficiency over 20 hours while producing DHA, and formic acid.