This paper presents the application of optimization methods to synthesize the radiation pattern of linear antenna arrays. The performance comparison between Particle Swarm Optimization (PSO) and Genetic Algorithm (GA) to obtain different pattern shapes is realized. The techniques are applied for a linear array of isotropic elements, and, subsequently, for a microstrip array.
4 October 2019 in IEEE Antennas and Wireless Propagation Letters
This letter presents a new approach for the enhancement of the axial ratio (AR) of a single-layer circularly polarized reflectarray antenna based on a circular microstrip patch with phase delay-line stubs unit cell. The AR improvement is achieved by inserting insets around the two stubs, changing the orientation of one of them and using a mirror symmetry arrangement. Two prototypes have been designed, fabricated, and tested to proof the proposed concept in K-band. A good agreement has been obtained between numerical simulations and experimental results. The measured results confirm a remarkable AR improvement with values below 1 dB and 3 dB gain and AR bandwidths larger than 23.7%.
27 July 2015 in International Journal of Antennas and Propagation
This paper presents an analysis for optimal design of switched beamforming applied to a linear array for wireless communication systems. The beam switching scheme provides coverage of a given sector in azimuth and controls the sidelobe level simultaneously. The analysis was developed considering arrays composed of Quasi-Yagi elements. The model assumes a user moving in the azimuthal direction under a constant velocity and with an estimation of the signal-to-noise ratio (SNR) at the mobile user (MU). The radio base station applies the beam that yields the best performance during transmission. The decision is based on the feedback information received from the MU. The goal of the analysis is to determine the best trade-off between the array size and number of feedback bits necessary to maximize the SNR at the receiver. The results show that a compromise between the number of beam-pointing directions and the array size should be taken into consideration for a wireless communication system design.
This paper presents the application of optimization methods for the synthesis of a linear array for radio base stations of mobile communications systems. The desired pattern shall exhibit squared-cosecant shape, so as to provide uniform distribution of power inside the base station cell and to reduce co-channel interference. The synthesis is performed by a combination of optimization methods: the genetic algorithm is used for the initial global search, then the sequential quadratic programming is applied for local search. This approach allows faster convergence than using only one kind of optimization method. The technique is demonstrated for a linear array of isotropic elements and, subsequently, for an array of microstrip antennas.
25 October 2018 in IET Microwaves, Antennas & Propagation
This study presents the study of beamforming capabilities of arrays installed on a non‐conductive unmanned aerial vehicle (UAV). The main purposes of this study are the application of a beamforming algorithm by including the airframe in the optimisations and the study of simplifications of the aircraft model, so as to allow performing full‐wave simulations, even though the UAV is much larger than the operating wavelength. To validate the simplified electromagnetic model, antenna arrays have been designed and installed onto the UAV. Radiation pattern measurements demonstrate that the proposed simplifications yielded very good radiation pattern predictions and can be used as guidelines for simulation of other kinds of non‐conductive aircrafts.
1 March 2016 in IET Microwaves, Antennas & Propagation
This study presents a technique to design antenna arrays with shaped radiation pattern. The efficiency of the proposed technique is demonstrated for the optimisation of a linear microstrip array for radio base stations of mobile communication systems. The main beam is shaped so as to provide uniform distribution of power inside a sector of a cell and to minimise the power radiated above the horizon. The synthesis of the shaped pattern is achieved by a combination of genetic algorithm and sequential quadratic programming. In contrast to several papers found in the literature that consider only isotropic antennas, the proposed approach takes into account all the radiation properties of small arrays, such as the mutual coupling between the array elements and edge effects. Finally, the design of the feeding system to produce the synthesised pattern is discussed. Measurements are used to validate the proposed technique.