28 March 2022 in IEEE Transactions on Antennas and Propagation
This communication proposes a novel unit cell for the design of dual-band dual-circularly polarized reflectarrays for space communications. The main advantage of the proposed cell is the use of one single layer for the antenna fabrication, hence yielding lower costs and fabrication with lower complexity in comparison to multilayer antennas. The proposed cell is used to design a dual-band dual-circularly polarized reflectarray with widely separated bands. Due to the physical symmetry, it provides very good polarization characteristics. The antenna performance is validated by far-field measurements and very good agreement between simulated and measured results has been verified.
1 March 2019 in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
This paper describes the application of the Firefly Algorithm for the optimization of linear and planar antenna arrays. In order to demonstrate the potential of this technique, three applications are reported. The first one is the synthesis of a radiation pattern with isoflux distribution with a non-uniformly spaced linear array composed of isotropic antennas. The second application is the optimization of a non-uniformly spaced planar array composed of isotropic radiators installed on an 8-U nanosatellite. Finally, the optimization of a 3×3 planar antenna array for beam steering with simultaneous side lobe level control is described, whereby the beamforming coefficients were allowed to assume only discrete values. In the three cases considered, good agreement between the desired (mask) and the optimized patterns has been obtained.
1 March 2023 in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
4 October 2019 in IEEE Antennas and Wireless Propagation Letters
This letter presents a new approach for the enhancement of the axial ratio (AR) of a single-layer circularly polarized reflectarray antenna based on a circular microstrip patch with phase delay-line stubs unit cell. The AR improvement is achieved by inserting insets around the two stubs, changing the orientation of one of them and using a mirror symmetry arrangement. Two prototypes have been designed, fabricated, and tested to proof the proposed concept in K-band. A good agreement has been obtained between numerical simulations and experimental results. The measured results confirm a remarkable AR improvement with values below 1 dB and 3 dB gain and AR bandwidths larger than 23.7%.
27 July 2015 in International Journal of Antennas and Propagation
FFFilipe Guterres Ferreira
This paper presents an analysis for optimal design of switched beamforming applied to a linear array for wireless communication systems. The beam switching scheme provides coverage of a given sector in azimuth and controls the sidelobe level simultaneously. The analysis was developed considering arrays composed of Quasi-Yagi elements. The model assumes a user moving in the azimuthal direction under a constant velocity and with an estimation of the signal-to-noise ratio (SNR) at the mobile user (MU). The radio base station applies the beam that yields the best performance during transmission. The decision is based on the feedback information received from the MU. The goal of the analysis is to determine the best trade-off between the array size and number of feedback bits necessary to maximize the SNR at the receiver. The results show that a compromise between the number of beam-pointing directions and the array size should be taken into consideration for a wireless communication system design.
21 November 2018 in IEEE Antennas and Wireless Propagation Letters