Depletion of fossil fuels and greenhouse gases is an essential issue in the development of the automotive industry. From the design stage, material selection becomes the most crucial factor. Therefore, this article discusses the development of lightweight automotive materials for increasing fuel efficiency and reducing carbon emissions. Material reliability is assessed by how much weight reduction can be achieved, production costs, safety and durability. Ferro materials (mild steel, High Strength Steel, and Advanced High Strength Steel), non-ferrous (aluminium and magnesium alloy), and Fiber Reinforced Plastics (FRP) have been proven to reduce the total weight of vehicles up to 12.6%. Confirmation of statistical data from the literature illustrates the possibility of using lightweight material to achieve zero CO2 emission. In addition, the 12.6% weight reduction still meets the vehicle safety factor.
This paper presents a study on the effect of the mixed volume fraction of Jatropha curcas Oil (JCO) and Olea europea or extra virgin olive oil (EVOO) on the physical properties of the oil, especially viscosity, density and water content. This study also presents the mechanical properties examination result, especially its effect on the wear rate of the pin on disc tribometer results on ST 41 steel specimens, using optical microscopy. The independent variables used were variations of the oil mixture: 0, 20, 40, 60, 80 and 100% EVOO. With the increase in the percentage of the EVOO mixture in JCO, the density decreases. The result of water content in a higher percentage of JCO, the higher the water content value of 0.1217%. Pure JCO has the higher viscosity value of 1.9084 m2/s. The higher the percentage of JCO, the lower the wear rate value obtained. In the tribometer test, the pin on disk mixture of pure JCO has the lower wear value of 5.09 m2/s.
Resistance Spot Welding merupakan metode pengelasan yang kompleks, yang melibatkan intraksi listrik, termal, mekanik, dan metalurgi. Dimana dalam prosesnya terdapat tiga parameter umum yang mempengaruhi Resistance Spot Welding arus listrik (welding current), tekanan elektroda (electrode force), dan siklus pengelasan. Tujuan dari penelitian ini adalah untuk mengetahui pengaruh variasi ketebalan pada proses Resistance Spot Welding terhadap sifat fisis pada material Alumunium 2024 T42 dengan variasi ketebalan 0.5 + 1.2 + 0.6 mm, 0.8 + 0.6 + 1.0 mm, dan 0.8 + 1.2 + 1.2. Pengujian yang dilakukan yaitu uji tarik (tensile-shear test), dan uji macrography. Hasil pengujian dari setiap variasi ketebalan memenuhi standart AWS D17.2 dengan nilai lebih dari 140 lbf.
This study investigates the effects of fiber treatments on mechanical properties of pineapple leaf fiber reinforced polyester composites (PALF/PE). The Fiber treatments were conducted with 3%, 6% and 9% NaOH for 2 hours. The untreated and treated PALF/PE composites were fabricated by the vacuum infusion method. The result analysis revealed that PALF/PE composites treated with NaOH indicated an increasing pattern in mechanical properties compared to untreated PALF/PE composites. The highest tensile strength was112 Mpa at 6 % NaOH and the highest impact strength was 0.11891 Joule/mm2 at 6 % NaOH. Moreover, the fracture images indicate relatively less fiber pull-out and improved fiber/matrix adhesion. The composites would be promising for construction, furniture and automotive materials due to their superior mechanical properties.