Within the scope of developing a multi-physical model describing battery behavior during and after the mechanical load (accelerations, intrusions) of a vehicle’s high voltage battery, an internal short circuit model is of deep interest for a virtual hazard assessment. The internal short resistance and the size of the affected area must be known as a minimum for determining the released heat and, in consequence, the temperatures. The internal short resistance of purpose-built dummy pouch cells, filled with electrolyte-like solvent without conductive salt, has thus been measured in a given short area under various compressive loads. The resistances for different short scenarios obtained are analyzed and described in a mathematical form. Short circuit experiments with dummy cells using an external power source have also been carried out. This set-up allows the measurement of the temperature evolution at a known current and a determination of the actual short resistance. The post-mortem analysis of the samples shows a correlation between the maximum temperatures, released short heat and the separator melt diameter.