In present work the BIOLIGNIN{trade mark, serif} obtained in the result of wheat straw organosolv processing in CIMV pilot plant (France) was investigated as a component of rigid polyurethanes (PUR) foam systems. Different separate approaches of lignin introduction into PUR foam system were studied: as filler without chemical preprocessing and as liquid lignopolyol obtained by lignin oxypropylation in alkali conditions. The incorporation of increasing amount of lignin as filler into reference PUR foam systems on the basis of mixture of commercial polyethers Lupranol 3300 and Lupranol 3422 steadily decreased the compression characteristics of foams, their dimensional stability and hydrophobicity. The complete substitution of Lupranol 3300 by lignopolyol increases its cell structure uniformity and dimensional stability and does not reduce the physical-mechanical properties of foam. In both cases the incorporation of lignin into PUR foam leads to the decreasing of maximum values of thermodegradation rates. The lignin filler can be introduced into lignopolyol based PUR foam in higher quantity than in the reference Lupranol based PUR without reduction of compression characteristics of material. In this work the optimal lignin content in the end product - PUR foam as both polyol and filler is 16%.

The barks of aspen (Populus tremula) and pine (Pinus sylvestris) are byproducts of wood processing, characterized by their low economic value. In the present study, microwave-assisted one-cycle water extraction was explored as a tool for the valorization of this biomass as a source of biologically active compounds. The microwave extractor of the original construction equipped with a pressurized extraction chamber and a condenser section was used. The microwave-assisted extraction (MAE), specially including dynamic dielectric heating up to 70 °C followed by 30 min of isothermal heating, promoted the isolation of salicin from aspen bark, allowing for the obtention of a two-times-higher free salicin concentration in water extracts (−14% vs. 7%) reached by multi-cycle accelerated solvent extraction (ASE), which is an advanced technique used as a reference. The MAE of pine bark with dynamic heating up to 90–130 °C, avoiding the isothermal heating step, allowed for the obtention of a 1.7-times-higher concentration of proantocyanidin dimers-tetramers, a 1.3-times-higher concentration of catechin and a 1.2-times-higher concentration of quinic acid in water extracts in comparison to a more time- and solvent-consuming ASE performed at the same temperature. The biological activity of the obtained extracts was characterized in terms of their ability to inhibit xahntine oxidase enzyme, which is a validated target for the therapeutic treatment of hyperuricemia.