Here, we report a simple and versatile synthesis of low-dimensional ZnO nanosheet (NS) arrays modified with Fe₂O₃ (hematite) to assemble photocatalytic coatings and non-enzymatic glucose sensors. Photocatalytic coatings made of widespread elements (zinc and iron) were tested for methylene blue (MB) dye decolorization under ultraviolet and visible (UV-vis) irradiation. A comparative study of unmodified and modified ZnO NS photocatalysts revealed a significant decrease in the dye concentration in 180 min when ZnO/Fe₂O₃ arrays were used. Size dependence efficiency of the hematite layer deposited onto ZnO is presented. A study of the sensitivity of biosensors made of ZnO nanostructures and ZnO/Fe₂O₃ nanocomposites for glucose detection showed an improvement in sensitivity with increased Fe₂O₃ thickness. The structure and morphology of low-dimensional coatings were studied by X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy dispersive X-ray analysis (EDX). The optical properties of nanoarrays showed a red shift of absorption after modifying ZnO with hematite layers, which holds good promise for expanding photocatalytic activity in the visible region.

Properties of heterotructured semiconductors based on ZnO/CdS nanosheets are investigated for their possible application in photocatalytic and photoelectrochemical reactions. Semiconductor material is the main active coating of photoanodes, which triggers the half-reaction of water oxidation and reduction, which entails the purifying or splitting of water. This article explains nanocomposite assembly by convenient and simple methods. The study of the physicochemical properties of semiconductor layers is carried out using electron microscopy, X-ray diffractometry, and UV-visible spectroscopy. Studies of electrochemical properties are carried out by potential static methods in electrochemical cells.

Exploitation of common elements as photocatalysts for conversion of photons to electricity stimulates the development of a green energy strategy. In this paper, methods for the preparation of active coatings based on ZnO/Ag/CdS, which are used in the photocatalytic oxidation reaction, are examined. The physical and chemical properties of the resulting arrays were studied using optical spectrometers, an electron microscope, an X-ray diffractometer, and potentiostatic measurements and electrochemical impedance spectroscopy. The effectiveness of photocatalysts was calculated by the ability to liberate gas from aqueous solutions when exposed to light. The rate of degradation was indirectly measured with a conductometer.