Organic solar cells (OSCs) are suitable candidates for next‐generation renewable energy sources due to their low cost of production and flexibility. Their power conversion efficiency has improved significantly to about 20% in both single‐ and multi‐junction devices due to the tremendous work in optimizing the synthesis of novel active‐layer materials while improving device fabrication. Despite a few reports predicting a 20‐year lifetime for OSC devices, their stability currently lags behind their commercialization. This Review discusses the issues that impair OSC stability and how to mitigate them. While emphasizing the importance of the International Summit on Organic Photovoltaic Stability (ISOS) protocols, an overview of recent advancements in OSC power conversion efficiency (PCE) and lifetime is provided. Finally, fundamental challenges to developing high‐performance and stable OSCs are discussed along with general recommendations for improving the stability of OSCs.
In recent days, metallic oxide semiconductor nanoparticles have drawn attention to the photocatalytic degradation of organic pollutants. In the present work, undoped and different metals (Sn, Co, Cu, Ni, and Li)-doped of α-PbO nanoparticles were successfully synthesized by a facile chemical precipitations method. The obtained nanoparticles were further studied by using different characterization techniques. The XRD results confirmed that the prepared nanoparticles were a tetragonal, α-PbO phase crystal structure without mixing other PbO phases. The obtained optical band gaps from UV–vis DRS analysis were 2.03 eV, 2.68 eV, 1.61 eV, 1.78 eV, 1.67 eV, and 2.00 eV for pristine α-PbO, Sn, Co, Cu, Ni, and Li doped α-PbO respectively. From the PL emission, the lowest PL intensity of the doped samples indicated the low recombination of the electron-hole pairs that improved the photocatalytic performance of pristine α-PbO. SEM and EDX were used to analyze the surface morphology and composition of the synthesized nanoparticles, respectively. The photocatalytic activities of the prepared nanoparticles were assessed through the degradation of the Methylene Blue (MB) dye under visible light irradiation. The UV–visible spectrophotometer analysis showed that the MB dye concentration decreased as the irradiation time varied from 20 to 100 min. The results showed that within 100 min, the Sn-doped α-PbO nanoparticles possessed the maximum degradation efficiency compared to other metal-doped α-PbO nanoparticles, with 100% MB dye degradation compared to 94.76% by pristine α-PbO. This was due to the increased visible light harvesting, which aided in the photocatalytic degradation of MB dye.
Recently, plasmonic nanoparticles (NPs) have attracted considerable attention as good candidates for enhancing the power conversion efficiency (PCE) of organic solar cells (OSCs) owing to their localized surface plasmon resonance (LSPR). In this study, the effect of embedding colloidal gold nanoparticles (cAu NPs) in the ZnO electron transport layer (ETL) on the PCEs of wide band gap polymer-based inverted OSCs was investigated. The active layer was composed of a bulk heterojunction of conjugated polymer based on indacenodithieno[3,2-b]thiophene and 5,5′-di(thiophen-2-yl)-2,2′-bithiazole PIDTT-DTBTz as a donor and [6,6]-phenyl-C71-butyric acid methyl ester (PC71BM) as an acceptor. The PCE of the reference device was improved by 22% when 10 wt% cAu NPs were embedded in the ZnO ETL. The short circuit current density (JSC) and fill factor (FF) were the main photovoltaic parameters contributing to the PCE enhancement. An improved absorption in the active layer due to the LSPR of cAu NPs as well as efficient exciton dissociation and charge collection were found to be the reasons for the enhanced JSC while the increase in FF was mainly due to the suppressed traps and improved conductivity of the ZnO layer by the NPs.