Climate warming can alter the thermal conditions of reservoirs. However, some hydraulic interventions can be explored to mitigate this impact. This study investigates the long-term effects of climate on the temperature and thermal structure of a monomictic reservoir that has had varying operations from 1959 to 2016. Reservoir progressively operated through three distinct periods, namely, (A) deep penstock withdrawal (DPW; 1959–1991), (B) purely selective withdrawal (SW; 1992–2001), and (C) combination of SW and vertical curtain (VC; 2002–2016). Although annual air temperatures are increasing (+0.15 °C decade−1) in the long term, the reservoir’s surface water temperatures have been found to be decreasing (−0.06 °C decade−1). Periods B and C produced colder profiles and exhibited lower heat content and higher potential energy anomaly than Period A. Furthermore, stronger thermoclines, as indicated by Brunt–Vaisala frequency, were observed in the two latter periods. The results of this study show that varying operations bear a stronger influence on the reservoir’s temperature and thermal structure than climate change itself. Mitigating the thermal impacts of climate warming in reservoirs appears promising with the use of SW and VC.
Three-dimensional hydrodynamic modeling for small, stratified tropical lakes in the Philippines and in Southeast Asia in general is not deeply explored. This study pioneers investigating the hydrodynamics of a small crater lake in the Philippines with a focus on temperature simulation using a Fantom Refined 3D model that has been tested mostly for temperate and sub-tropical lakes. The lake’s monthly temperature during the dry season served as a reference for the model’s initial condition and validation. For the simulation to proceed, input data such as weather, inflow, and bathymetry were prepared. In the absence of hourly meteorological data from local weather stations, this paper adopted the satellite weather data from Solcast. Simple correlation analysis of daily weather data between local stations and Solcast showed valid and acceptable results. Inflow values were estimated using the rational method while the stream temperature was estimated from a regression equation using air temperatures as input. The validated satellite-derived data and runoff model can therefore be employed for 3D modeling. The simulations resulted in extremely higher temperatures compared with those observed when using previous default model settings. Direct modifications were then applied to weather parameters, compromising their integrity but resulting in reasonable profiles. By adding scaling factors to heat flux equations and multiplying their components by 0.75 (shortwave), 1.35 (longwave), 0.935 (air temperature), and 0.80 (wind), better results were achieved. This study identifies several challenges in performing 3D hydrodynamic modeling, such as paucity in input hydro-meteorologic and limnologic data and the need for heat flux model improvement. Overall, this study was successful in employing 3D hydrodynamic modeling in a tropical lake, which can pave directions and serve as an excellent reference for future modeling in the same region.
29 June 2024 in Journal of Environmental Management
Hydrodynamic modeling in reservoirs usually implements the Uniform Distribution Method (UDM) for outflows. While this may work well in single-point portals like for deep penstock withdrawal (DPW), the case may be different for selective withdrawal (SW). Using actual observations of velocity fields through the SW facility of the Ogouchi Reservoir, a new outflow method called the Modified Gaussian Distribution Method (MGDM) was applied to simulate the in-reservoir and outflow temperatures. Results showed that MGDM can reproduce the two thermal properties more reasonably than UDM. Using these techniques, the three conceptual cases were formulated namely, Case A (DPW), B (SW) and C [SW and vertical curtains (VC)]. Case A has wider thermal dispersion and exhibits cold water pollution while Cases B and C develop stronger thermoclines and can mitigate the thermal pollution. Case C has wider epilimnion than B due to the VC yet simulation shows similar trends for outflow temperatures for B and C due to similar release operations. In modeling reservoirs with SW, it is highly recommended to measure the actual velocity field of the outflow and apply these measured velocity distributions in the simulation. MGDM is promising for modeling with better accuracy not only for the reservoir temperatures but also for the sediment and other water quality distributions.