Hydrodynamic modeling in reservoirs usually implements the Uniform Distribution Method (UDM) for outflows. While this may work well in single-point portals like for deep penstock withdrawal (DPW), the case may be different for selective withdrawal (SW). Using actual observations of velocity fields through the SW facility of the Ogouchi Reservoir, a new outflow method called the Modified Gaussian Distribution Method (MGDM) was applied to simulate the in-reservoir and outflow temperatures. Results showed that MGDM can reproduce the two thermal properties more reasonably than UDM. Using these techniques, the three conceptual cases were formulated namely, Case A (DPW), B (SW) and C [SW and vertical curtains (VC)]. Case A has wider thermal dispersion and exhibits cold water pollution while Cases B and C develop stronger thermoclines and can mitigate the thermal pollution. Case C has wider epilimnion than B due to the VC yet simulation shows similar trends for outflow temperatures for B and C due to similar release operations. In modeling reservoirs with SW, it is highly recommended to measure the actual velocity field of the outflow and apply these measured velocity distributions in the simulation. MGDM is promising for modeling with better accuracy not only for the reservoir temperatures but also for the sediment and other water quality distributions.
Soil water storage properties, which are affected by land management practices, alter the water balance and flow regimes in watersheds; thus, it is highly plausible to clarify the influence of such management practices on the water storage condition by analyzing the long-term variations in discharge. In this study, the changes in soil water storage characteristics of the Ogouchi Dam watershed, which had undergone intensive forest management through the decades, were investigated using two approaches. Reported results from the rainfall–runoff correlation analysis show a gradual and steady increase in the soil water storage capacity at weaker continuous-rainfall events, i.e., uninterrupted wet days accumulating less than 70 mm. Meanwhile, the second approach utilizing the parameter calibration in the SWAT discharge model illustrated a constant trend in the runoff potential and the high possibility of a steady improvement in the soil available water capacity. Overall, the established decadal trends were able to prove the capability of sustainable forest management, i.e., thinning, regeneration cutting, multi-layer planting, deer-prevention fences, and earth-retaining fences (lined felled trees), in improving the water conservation function of the catchment.
In recent years, leakage detection models using artificial intelligence have been widely used by researchers. In this study, acoustic sound data were recorded at 10 observation points, focusing on ductile iron pipe and vinyl polyethylene. Leakage detection models were built using recurrence plots (RPs) and a convolutional neural network (CNN). Using the same number of RPs for training data and testing data, we analyzed the effect of data variations on model performance. The results showed that our proposed approach can improve accuracy at several points, although the amount of training data information was advantageous in previous work. There were cases in previous work that had poor accuracy, but when implementing our proposed approach, it improved the accuracy to over 80% when using the 8-point model. The increase in accuracy depends on which interval is used in the test data because each interval contains information about different properties. For multi-point models, the effect of increasing the number of RPs and data variations was not clarified in the previous work. However, our study confirmed that the increase in data variation contributed more than the RP number.
4 September 2023 in PHM Society Asia-Pacific Conference
Inspection of water pipelines with cameras under pressure is attracting attention. The inspection can be performed without digging the ground and water interruption by inserting a camera into aging water pipes while the water is flowing. However, the inspection has two problems: (1) a long-time visual check by expert engineers is required and (2) variations in the evaluation standards. To solve these problems, we have developed an AI image analysis system for automatically judging the state of degradation of water pipelines by using images captured from the in-pipe endoscope cameras. This report describes the developed technology and software to support the inspection work.
This study aimed to assess and improve the accuracy of a water leakage detection model proposed in preliminary research. The poor results for water leakage sound (recall) and background noise (specificity) were clarified using countermeasures in accordance with each condition. Additionally, frequency amplification in the range of 500–600 Hz, the attenuation of weak components, and a band-stop filter were used to remove the 50 Hz component and harmonics. Pre-processing was carried out in the form of amplification, with weak noise removed using a band-stop filter. The results showed that the application of the proposed model improved the detection accuracy by 80% at the observation points that initially had poor accuracy. Thus, the proposed method was effective at improving the performance of the Recurrence Plot-Convolutional Neural Network (RP-CNN) model for detecting water leakages.
This research aims to determine and improve accuracy of a water leakage detection model proposed in preliminary research. The poor results for water leakage sound (recall) and background noise (specificity) were clarified using countermeasures in accordance with each condition. Additionally, frequency amplification in the range of 500–600 Hz, attenuation of weak components, and a band-stop filter were used to remove the 50 Hz component and harmonics. Pre-processing was carried out in the form of amplification with weak noise removed using a band-stop filter. The results showed that application of the proposed model improved detection accuracy by 80% at observation points that initially had poor accuracy. Thus, the proposed method was effective in improving performance of the RP-CNN model in detecting leakage.