Temporal evolution of an ignition kernel in a spark ignited turbulent hydrogen–air mixing layer is studied using the large eddy simulation approach with an implicit treatment of the reaction source terms. The applied numerical code is based on a high-order compact difference approximation combined with a weighted essentially non-oscillatory scheme, which provide an accurate resolution of the small scale phenomena. The spark is modelled by an energy deposition model coupled with the enthalpy equation. Since the fuel and oxidiser streams move in the opposite directions the flow is dominated by shear stresses and vortical structures. The ignition follows three different scenarios depending on the spark location. An interaction between the developing flame kernel and large turbulent structure is analysed starting from the energy transfer up to a fully reacting state. The size and shape of the flames are correlated with the initial ignition scenario. A 3D visualisation of the transient position of the flame kernel shows its different spatio-temporal behaviour. It is observed that the flame can stay close to the initial position and spread equally in all directions or it can move far from the initial location and follow the evolving flow field. In the latter scenario two separate sub-stages are convincingly identified. Concerning the ignition probability ( $$P_{ign}$$ ), when the spark is located in the immediate vicinity of the mixing layer, the $$P_{ign}$$ on the fuel-rich side is higher. On the other hand, when the ignition occurs far from the mixing layer, the $$P_{ign}$$ is significantly larger on the lean side. Unlike the local composition the impact of the strain rate of the velocity field was found to have very limited impact on the $$P_{ign}$$ .
1 May 2018 in International Journal of Hydrogen Energy
Purpose: The purpose of the paper is to summarize recent achievements and suggest further research directions in numerical studies of round free jets with particular attention on the influence of the inlet parameters (mean velocity, turbulence intensity, length and time scales) on the jet dynamics. Design/methodology/approach: The large eddy simulation (LES) and direct numerical simulation (DNS) are regarded as accurate tools which can support expensive and requiring sophisticated measurements techniques experimental studies. In the paper, the authors present challenges and recent findings related to the LES and DNS of jet type flows in isothermal, heated, excited and reactive conditions. Findings: LES of the isothermal jet allowed to identify the new jet instability mechanism leading to the self-sustained oscillations and to determine conditions required to trigger this phenomenon. Numerical simulation on the low-density round jet captured the phenomenon of absolute instability with a very good agreement with the experimental findings. LES/DNS of excited jet exhibited bifurcating and blooming jet and showed that the jet can be directly controlled by excitation frequency what is crucial issue also for flame shape control. Originality/value: The paper shows complexity of seemingly simple jet type flow and proves that despite a huge interest in these flows and relatively deep knowledge on the jet dynamics there are still some open issues requiring further studies.
31 May 2023 in International Journal of Heat and Mass Transfer