The substitution of mineral aggregates with crumb rubber (CR) from waste end-of-life tires (ELTs) in the asphalt concretes, has been considered a sustainable paving industry approach. The rubber has been used to construct pavements with proven enhanced resilience and improved durability. However, some issues related to the rubber’s surface adhesion or swelling may arise with these practices and generate complications (binder consumption, temperatures, mixing times). One possible solution to overcome the materials’ compatibility problems is to pre-treat the CR’s surface before its incorporation into the asphalt mixes to allow a surface functionalization that can enhance coverage and cohesion inside the mixes. The physical treatments using radiations-based beam are already exploited in the plastic recycling industries avoiding the use of chemicals in considerable amounts. Such treatments permit the recovering of large quantities of polymer-based materials and the enhancement of interfacial properties. This article provides an overview of existing surface treatments of polymers and especially rubber, including gamma ray, UV-ozone, microwaves, and plasma. Several studies have shown an overall improvement of the rubber surface’s reactive properties due to contaminant removal or roughness enhancement attributed to cross-linking or scission reactions occurring on the rubber’s surface layer. With those properties, the asphalt mixes’ phase stability properties are increased when the pre-treated rubber is incorporated. The treatments would permit to increase the CR quantities, yet reduce the layer stiffness, and improve the durability and the sustainability of future advanced road pavements.
Cyclists, pedestrians and elderly people’s specific needs in urban road infrastructures are often neglected. They rarely benefit from safety measures or innovations. Inspired by playgrounds and aiming to reduce vulnerable road users (VRUs) injuries, the development of the rubber-based impact-absorbing pavements (IAP) offers a possibility to rethink the design of urban pavements and address safety on roads, which constitutes a major challenge in terms of attaining more sustainable, resilient, and safe cities. Therefore, bituminous mixtures with four different crumb rubber contents, 0%, 14%, 28%, and 33% (in total weight), were produced by partial aggregates substitution using the dry process. After the assessment of the geometrical and volumetric properties, the mechanical performances were evaluated. Finally, the samples were tested to measure the abrasion and impact attenuation with the well-known head injury criterion (HIC), at different temperatures from −10 to 40 °C, to obtain a wide range of values referring to possible weather conditions. A significant effect of the rubber percentage and layer thickness on impact attenuation was observed. All observations and results confirm the feasibility of the IAP concept and its positive effect on future injury-prevention applications.