This study aims to evaluate the physicochemical properties of rubberwood sawdust (RWS) and sewage sludge (SS) for producing biofuel or liquid products via pyrolysis and co-pyrolysis. The chemical and thermal properties of both samples were observed to have superior bioenergy production capabilities. RWS and SS had significantly different physicochemical properties, such as particle-size distribution, bulk density, ultimate and proximate analysis, lignocellulose composition, thermal-degradation behaviour, and major and minor elements. The composition of extractives was found to only marginally affect the end product. Carbon and hydrogen content, the two main elements for biofuel enhancement, were found to correlate with the organic components of both RWS (48.49, 7.15 wt.%) and SS (32.29, 4.06 wt.%). SS had a higher elemental composition of iron, calcium, and potassium than RWS. Both samples had a higher heating value of 13.98 to 21.01 MJ/kg and a lower heating value of 11.65 to 17.66 MJ/kg, a lesser energy potential than that of fossil fuels. The findings from these blends are relatively moderate due to the related lignocellulosic potential composition. The novel contribution of this research was to optimize the use of local waste materials as a new raw material for biofuel production that could serve as a sustainable fuel source.
The study aimed to purify trypsin from the pyloric caeca of Asian seabass (Lates calcarifer), and investigate its proteolytic capability toward acid-soluble collagen (ASC) in comparison with commercial porcine trypsin (CPT). Trypsin was purified from pyloric caeca, a leftover from the evisceration process, via ammonium sulphate (40–60% saturation) precipitation, and a soybean trypsin inhibitor (SBTI)–Sepharose 4B column. A 18.5-fold purification and a yield of 15.2% were obtained. SDS-PAGE analysis confirmed a single band of trypsin with a molecular weight of 23.5 kDa. Purified trypsin also showed the single band in native-PAGE. The optimal pH and temperature of trypsin for BAPNA (the specific substrate for amidase) hydrolysis were 8.5 and 60 °C, respectively. The trypsin was stable within the pH range of 7.0–9.5 and temperature range of 25–55 °C. Protease inhibition study confirmed that the purified enzyme was trypsin. The purified trypsin had a Michaelis–Menten constant (Km) and catalytic constant (kcat) of 0.078 mM and 5.4 s−1, respectively, when BAPNA was used. For the hydrolysis of TAME (the specific substrate for esterase), the Km and Kcat were 0.09 mM and 4.8 s−1, respectively. Partially purified seabass trypsin (PPST) had a slightly lower hydrolysis capacity toward ASC than CPT, as evidenced by the lower degree of hydrolysis and protein degradation when the former was used. Both the α-chain and β-chain became more degraded as the hydrolysis time increased. Based on MALDI-TOP, peptides with MW of 2992-2970 Da were dominant in the hydrolysates. Therefore, seabass trypsin could be used in the production of hydrolyzed collagen. It could have economic importance to the market, by replacing some commercial proteases, which have religious constraints.
Human milk lipids generally have the maximum long-chain fatty acids at the sn-2 position of the glycerol backbone. This positioning makes them more digestible than long-chain fatty acids located at the sn-1, 3 positions. These unique fatty acid distributions are not found elsewhere in nature. When lactation is insufficient, infant formula milk has been used as a substitute. However, the distribution of most fatty acids ininfant formula milk is still different from human milk. Therefore, structured lipids were produced by the redistribution of medium-chain fatty acids from commercial butterfat (CBF) and n-3 and n-6 long-chain fatty acids from skipjack tuna eyeball oil (STEO). Redistribution was carried out via transesterification facilitated by Asian seabass liver lipase (ASL-L). Under the optimum conditions including a CBF/STEO ratio (3:1), transesterification time (60 h), and ASL-L unit (250 U), the newly formed modified-STEO (M-STEO) contained 93.56% triacylglycerol (TAG), 0.31% diacylglycerol (DAG), and 0.02% monoacylglycerol (MAG). The incorporated medium-chain fatty acids accounted for 18.2% of M-STEO, whereas ASL-L could incorporate 40% of n-3 fatty acids and 25–30% palmitic acid in M-STEO. The 1H NMRA and 13CNMR results revealed that the major saturated fatty acid (palmitic acid) and unsaturated fatty acids (DHA and EPA) were distributed at the sn-2 position of the TAGs in M-STEO. Thus, M-STEO enriched with medium-chain fatty acids and n-3 fatty acids positioned at the sn-2 position of TAGs can be a potential substitute for human milk fatty acids in infant formula milk (IFM).
24 August 2020 in Applied Biochemistry and Biotechnology