San Fu Wang

San Fu Wang


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 September 2020 in Electronics
Verified
Journal Article
Open access
PDF file
San Fu WangSan Fu Wang
San Fu Wang
HCHua-Pin Chen
Hua-Pin Chen
YKYi-Tsen Ku
Yi-Tsen Ku
CLChia-Ling Lee
Chia-Ling Lee
This article presents a versatile voltage-mode (VM) biquad filter with independently electronic tunability. The proposed structure using one dual-output operational transconductance amplifier, three single-output operational transconductance amplifiers (OTAs) and two grounded capacitors was explored to derive a new VM quadrature oscillator with the independent control of the oscillation frequency and the oscillation condition. The proposed versatile VM biquad filter achieves nearly all of the main advantages: (i) simultaneous realizations of band-reject, band-pass, and low-pass from the same architecture, (ii) multiple-input and multiple-output functions, (iii) independent electronic adjustability of quality factor and resonant angular frequency, (iv) no resistor needed, (v) all input terminals with cascade functions, (vi) no additional inverting amplifier for input signals, (vii) using only grounded capacitors, and (viii) easy to implement a VM quadrature oscillator with independent electronically controlled oscillation frequency and oscillation condition. The proposed versatile VM biquad filter employs only four OTAs and two grounded capacitors. The active components of the proposed VM biquad filter are one less than that of recent reports. The proposed circuit also brings versatility and simplicity to the design of VM biquad filters and VM quadrature oscillators. Filters and oscillators with less active and passive components have the advantages of low cost, low power dissipation, low circuit complexity, and low noise. Commercially available integrated circuit LT1228 and discrete components can be used to implement the proposed OTA-based circuits. The simulation and experiment results validated the theoretical analysis.

4 June 2019 in Applied Sciences
Verified
Journal Article
Open access
PDF file
San Fu WangSan Fu Wang
San Fu Wang
HCHua-Pin Chen
Hua-Pin Chen
YKYi-Tsen Ku
Yi-Tsen Ku
PCPo-Yu Chen
Po-Yu Chen
This paper proposes a new high-input impedance current feedback operational amplifier (CFOA)- based voltage-mode multifunction biquadratic filter and a voltage-mode quadrature oscillator using the proposed high-input impedance CFOA-based biquadratic filter. The proposed high-input impedance CFOA-based voltage-mode multifunction biquadratic filter uses three CFOAs, three resistors, and two grounded capacitors with two inputs and three outputs. The filter can simultaneously realize non-inverting low-pass, non-inverting band-pass, and non-inverting band-reject filtering functions at the high-input impedance terminal while the inverting band-pass and non-inverting high-pass filtering functions can also be obtained by applying another high-input impedance terminal. The filter offers orthogonal control of resonance angular frequency and quality factor. The proposed high-input impedance CFOA-based voltage-mode multifunction biquadratic filter can be used to implement a voltage-mode quadrature oscillator with an independently controlled the frequency of oscillator and the condition of oscillation. The OrCAD PSpice simulation and experimental results of the commercially available integrated circuit, AD844AN, are used to confirm the characteristics of the proposed filter and oscillator.

22 November 2020 in Sensors
Verified
Journal Article
Open access
PDF file
San Fu WangSan Fu Wang
San Fu Wang
HCHua-Pin Chen
Hua-Pin Chen
YKYi-Tsen Ku
Yi-Tsen Ku
MCMing Hsiu Chung
Ming Hsiu Chung
This research introduces a new multifunction biquad filter based on voltage mode (VM) current-feedback operational amplifier (CFOA) and a fully uncoupled quadrature oscillator (QO) based on the proposed VM multifunction biquad filter. The proposed VM multifunction biquad filter has high impedance to the input voltage signal, and uses three CFOAs as active components, while using four resistors and two grounded capacitors as passive components. The VM CFOA-based multifunction biquad filter realizes band-reject, band-pass, and low-pass transfer functions at high-input impedance node simultaneously, which has the feature of easy cascading in VM operation without the need for additional voltage buffers. Additionally, the filter control factor parameter pole frequency (ωo) and quality factor (Q) of the proposed VM multifunction biquad filter can be independently set by varying different resistors. By slightly modifying the VM multifunction biquad filter topology, a VM fully-uncoupled QO is easily obtained. The difference from the previous VM CFOA-based multifunction biquad filter is that the proposed VM CFOA-based multifunction biquad filter can be independently controlled by the filter control factor parameters, ωo and Q. The proposed VM CFOA-based multifunction biquad filter can be transformed into a VM QO with fully-uncoupled adjustable of the oscillation condition and the oscillation frequency. The oscillation condition and the oscillation frequency can be fully-uncoupled and controlled by varying two sets of completely different resistors. The proposed VM fully-uncoupled QO solves the amplitude instability. The constant amplitude ratio of two quadrature sinusoidal waveforms can be realized when tuning FO. PSpice simulation and experimental results prove the performances of the proposed VM multifunction filter and VM fully-uncoupled QO. Simulation and experimental results confirm the theoretical analysis of the proposed circuits.

21 May 2019 in Sensors
Verified
Journal Article
Open access
PDF file
San Fu WangSan Fu Wang
San Fu Wang
HCHua-Pin Chen
Hua-Pin Chen
YKYi-Tsen Ku
Yi-Tsen Ku
YLYi-Chun Lin
Yi-Chun Lin
This paper presents a versatile tunable voltage-mode biquadratic filter with five inputs and three outputs. The proposed filter enjoys five single-ended output operational transconductance amplifiers (OTAs) and two grounded capacitors. The filter can be easily transformed into a quadrature oscillator. The filter with grounded capacitors is resistorless and electronically tunable. Either a voltage-mode five-input single-output biquadratic filter or a voltage-mode single-input three-output biquadratic filter can be operated by appropriate selecting input and output terminals. In the operation of five-input single-output biquadratic filter, the non-inverting lowpass, non-inverting bandpass, inverting bandpass, inverting highpass, non-inverting bandreject, inverting bandreject, and non-inverting allpass filtering responses can be realized by appropriately applying the input voltage signals. In the operation of single-input three-output biquadratic filter, the non-inverting/inverting lowpass, bandpass and bandreject filtering responses can be realized simultaneously. The circuit provides independent adjustment of the resonance angular frequency and quality factor, high-input impedance, and no inverting-type input voltage signals are imposed. The application in quadrature oscillator exhibits independent electronic tuning characteristic of the oscillation condition and the oscillation frequency. The theoretical analysis has been verified through OrCAD PSpice and furthermore by experimental measurements.

31 March 2019 in Journal of Circuits, Systems and Computers
Verified
Journal Article
Closed access
HCHua-Pin Chen
Hua-Pin Chen
San Fu WangSan Fu Wang
San Fu Wang
YCYu-Nan Chen
Yu-Nan Chen
QHQi-Geng Huang
Qi-Geng Huang

3 January 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
San Fu WangSan Fu Wang
San Fu Wang
HCHua-Pin Chen
Hua-Pin Chen
YKYi-Tsen Ku
Yi-Tsen Ku
YLYi-Fang Li
Yi-Fang Li
This paper proposes a high-input impedance voltage-mode (VM) multifunction biquad filter which employs three current-feedback amplifiers (CFAs), three resistors, and two grounded capacitors. The proposed VM multifunction biquad filter has single-input and triple-output and can realize non-inverting low-pass (NLP), inverting band-pass (IBP), and non-inverting band-stop (NBS) voltage responses at the same time without increasing component selection. The proposed VM multifunction biquad filter enjoys the orthogonal tunability of angular frequency and quality factor and also provides the advantage of using only two grounded capacitors, high-input impedance and low active/passive sensitivity. The performance of the proposed VM multifunction biquad filter is verified through its hardware implementation and OrCAD PSpice simulation based on AD844-type CFAs. The circuit analysis, sensitivity analysis, and NLP, IBP, and NBS voltage responses are also shown in this paper. The paper presents a method to effectively reduce the active and passive components, maintain good circuit performance, and reduce circuit costs.