Contact lenses (CLs) are prone to biofilm formation, which may cause severe ocular infections. Since the use of antibiotics is associated with resistance concerns, here, two alternative strategies were evaluated to endow CLs with antibiofilm features: copolymerization with the antifouling monomer 2-methacryloyloxyethyl phosphorylcholine (MPC) and loading of the antioxidant resveratrol with known antibacterial activity. MPC has, so far, been used to increase water retention on the CL surface (Proclear^® 1 day CLs). Both poly(hydroxyethyl methacrylate) (HEMA) and silicone hydrogels were prepared with MPC covering a wide range of concentrations (from 0 to 101 mM). All hydrogels showed physical properties adequate for CLs and successfully passed the hen’s egg-chorioallantoic membrane (HET-CAM) test. Silicone hydrogels had stronger affinity for resveratrol, with higher loading and a slower release rate. Ex vivo cornea and sclera permeability tests revealed that resveratrol released from the hydrogels readily accumulated in both tissues but did not cross through. The antibiofilm tests against Pseudomonas aeruginosa and Staphylococcus aureus evidenced that, in general, resveratrol decreased biofilm formation, which correlated with its concentration-dependent antibacterial capability. Preferential adsorption of lysozyme, compared to albumin, might also contribute to the antimicrobial activity. In addition, importantly, the loading of resveratrol in the hydrogels preserved the antioxidant activity, even against photodegradation. Overall, the designed hydrogels can host therapeutically relevant amounts of resveratrol to be sustainedly released on the eye, providing antibiofilm and antioxidant performance.

Design of advanced contact lenses (CLs) demands materials that are safe and comfortable for the wearers and that preserve the normal eye microbiota, avoiding chronic inflammation and biofilm development. This work aimed to combine the natural antibiofouling phosphorylcholine and the antioxidant and prebiotic resveratrol as integral components of CLs that may have the additional performance of preventing oxidative-stress related eye diseases. Different from previous uses of 2-methacryloyloxyethyl phosphorylcholine (MPC) as coating, we explored the feasibility of adding MPC at high proportions as a comonomer of 2-hydroxyethyl methacrylate (HEMA)-based hydrogels while still allowing for the loading of the hydrophobic resveratrol. Homogeneous distribution of MPC along the hydrogel depth (confirmed by Raman spectroscopy) notably increased solvent uptake and the proportion of free water while it decreased Young's modulus. Relevantly, MPC did not hinder the uptake of resveratrol by CLs (>10 mg/g), which indeed showed network/water partition coefficients of >100. Protocols for CLs sterilization and loading of resveratrol under aseptic conditions were implemented, and the effects of tear proteins on resveratrol release rate were investigated. CLs sustained resveratrol release for more than 24 h in vitro, and sorption of albumin onto the hydrogel, although attenuated by MPC, slowed down the release. The combination of MPC and resveratrol reduced P. aeruginosa and S. aureus growth as tested in a novel hydrogel disk-agar interface biofilm growth setup. The developed CLs showed excellent anti-inflammatory properties and biocompatibility in in ovo and rabbit tests and provided higher and more prolonged levels of resveratrol in tear fluid, which favored resveratrol biodistribution in anterior and posterior eye segments compared to eye drops. Correlations between the release profiles of resveratrol in vitro and in vivo were assessed. Relevantly, the CLs preserved the antioxidant properties of resveratrol during the entire 8 h of wearing. In sum, CLs prepared with high proportion in MPC may help address safety and comfort requirements while having drug releasing capabilities.

Statins are receiving increasing attention in the ophthalmic field. Their activity as 3-hydroxy-3-methylglutaryl–CoA (HMG–CoA) reductase inhibitors is clinically used to regulate cholesterol levels and leads to pleiotropic effects, which may help in the management of diabetes-related ocular pathologies. This work aims to design bioinspired contact lenses (CLs) with an affinity for atorvastatin by mimicking the active site of HMG–CoA reductase. Sets of imprinted and nonimprinted 2-hydroxyethyl methacrylate (HEMA) hydrogels were synthesized, varying the contents in functional monomers that bear chemical groups that resemble those present in HMG–CoA reductase, namely, ethylene glycol phenyl ether methacrylate (EGPEM), 2-aminoethyl methacrylate hydrochloride (AEMA), and N-(3-aminopropyl) methacrylamide hydrochloride (APMA). The hydrogels were characterized in terms of suitability as CLs (solvent uptake, light transmission, mechanical properties, and biocompatibility) and capability to load and release atorvastatin. Three sterilization protocols (steam heat, gamma radiation, and high hydrostatic pressure) were implemented and their effects on hydrogel properties were evaluated. Copolymerization of AEMA and, particularly, APMA endowed the hydrogels with a high affinity for atorvastatin (up to 11 mg/g; K_N/W > 200). Only high hydrostatic pressure sterilization preserved atorvastatin stability and hydrogel performance. Permeability studies through the porcine cornea and sclera tissues revealed that the amount of atorvastatin accumulated in the cornea and sclera could be effective to treat ocular surface diseases.

(1) Background: Mangiferin (MGN) is a natural compound, showing anti-inflammatory and antioxidant activities for the potential treatment of eye diseases. The poor physicochemical features of MGN (low solubility and high instability) justify its nanoencapsulation into nanostructured lipid carriers (NLC) to improve its ocular bioavailability. (2) Methods: Firstly, MGN-NLC were prepared by the high shear homogenization coupled with the ultrasound (HSH−US) method. Finally, unloaded and MGN-loaded NLC were analyzed in terms of ocular tolerance. (3) Results: MGN-NLC showed good technological parameters suitable for ocular administration (particle size below 200 nm). The ORAC assay was performed to quantify the antioxidant activity of MGN, showing that the antioxidant activity of MGN-NLC (6494 ± 186 μM TE/g) was higher than that of the free compound (3521 ± 271 μM TE/g). This confirmed that the encapsulation of the drug was able to preserve and increase its activity. In ovo studies (HET-CAM) revealed that the formulation can be considered nonirritant. (4) Conclusions: Therefore, NLC systems are a promising approach for the ocular delivery of MGN.

Cell membranes are emerging as valuable models for regulating scaffold‐cell interactions in tissue engineering. Their unique structure and function provide an ideal template for creating biomimetic surfaces that support cell adhesion, proliferation, and differentiation. This has led to the development of cell membrane‐coated scaffolds (CMCSs), a new class of biomaterials designed to mimic native cellular interfaces and improve therapeutic outcomes. This review begins with an overview of cell–extracellular matrix (ECM) interactions, highlighting their key roles in tissue remodeling and healing. It then introduces ECM‐inspired coatings before focusing on CMCSs. A detailed analysis of scaffolds coated with specific membrane components or entire cell membranes is presented, with applications in skin and wound healing, bone regeneration, neural repair, and vascular grafts. Techniques for membrane extraction, surface functionalization, and preservation of membrane integrity and orientation are analyzed. CMCSs demonstrate advantages over traditional scaffolds, including improved homotypic cell attraction, immune modulation, and resistance to non‐specific protein and bacterial adhesion. However, several challenges persist, such as standardizing membrane isolation methods, optimizing coating density, and evaluating the stability and reproducibility of coatings, especially when using hybrid membranes from multiple cell types. Overcoming these barriers could significantly advance scaffold technologies for regenerative medicine.

TPGS (D-α-tocopheryl polyethylene glycol 1000 succinate) polymeric micelles show interesting properties for ocular administration thanks to their solubilization capability, nanometric size and tissue penetration ability. However, micelles formulations are generally characterized by low viscosity, poor adhesion and very short retention time at the administration site. Therefore, the idea behind this work is the preparation and characterization of a crosslinked film based on xanthan gum that contains TPGS micelles and is capable of controlling their release. The system was loaded with melatonin and cyclosporin A, neuroprotective compounds to be delivered to the posterior eye segment. Citric acid and heating at different times and temperatures were exploited as crosslinking approach, giving the possibility to tune swelling, micelles release and drug release. The biocompatibility of the platform was confirmed by HET-CAM assay. Ex vivo studies on isolated porcine ocular tissues, conducted using Franz cells and two-photon microscopy, demonstrated the potential of the xanthan gum-based platform and enlightened micelles penetration mechanism. Finally, the sterilization step was approached, and a process to simultaneously crosslink and sterilize the platform was developed.