This paper deals with the control problems of a wind turbine working in its nominal zone. In this region, the wind turbine speed is controlled by means of the pitch angle, which keeps the nominal power constant against wind fluctuations. The non-uniform profile of the wind causes tower displacements that must be reduced to improve the wind turbine lifetime. In this work, an adaptive control structure operating on the pitch angle variable is proposed for a nonlinear model of a wind turbine provided by FAST software. The proposed control structure is composed of a gain scheduling proportional–integral (PI) controller, an adaptive feedforward compensation for the wind speed, and an adaptive gain compensation for the tower damping. The tuning of the controller parameters is formulated as a Pareto optimization problem that minimizes the tower fore-aft displacements and the deviation of the generator speed using multi-objective genetic algorithms. Three multi-criteria decision making (MCDM) methods are compared, and a satisfactory solution is selected. The optimal solutions for power generation and for tower fore-aft displacement reduction are also obtained. The performance of these three proposed solutions is evaluated for a set of wind pattern conditions and compared with that achieved by a classical baseline PI controller.
Individual pitch control (IPC) is a method to mitigate periodic blade loads in wind turbines, and it is typically implemented using the multi-blade coordinate (MBC) transform, which converts the blade load measurements from a rotating frame into the non-rotating tilt axis and yaw axis. Previous studies have shown that by including an additional tuning parameter in the MBC, the azimuth offset reduces the coupling between non-rotating axes, allowing for higher performance levels for diagonal controller structures. In these studies, the decentralized control of IPC was composed of two identical integral controllers. This work analyzes and compares the improvement that the azimuth offset can provide in different adaptive gain scheduling IPCs where the diagonal controllers can have integral or proportional action with different gains. They are applied to a 15 MW wind turbine simulated with OpenFAST v3.5 software. The controller parameter tuning is addressed as an optimization that reduces blade fatigue load based on the damage equivalent load (DEL) and is resolved through genetic algorithms. Simulations show that only using different controller gains in IPC does not provide significant improvements; however, including azimuth offset in the optimal IPC schemes with integral controllers allows for the greatest DEL reduction with a lower actuator effort.
The study of fatigue load reduction in wind turbines has gained significant interest in recent years. In monopile offshore wind turbines, vibrations induced by misalignment between waves and wind directions can considerably shorten the tower’s lifespan due to lateral loads. To cope with this issue, this work focuses on the design and evaluation of control strategies to mitigate these loads. An adaptive active generator torque control (AGTC) scheme is proposed to mitigate lateral tower fatigue within the nominal region. Two variants of AGTC are suggested: with or without using a bandpass filter. A multi-objective optimization using genetic algorithms is employed to determine the optimal AGTC parameters based on wind speed and wave height. Objective functions related to tower and low-speed shaft fatigue load reduction, as well as power fluctuation minimization, are employed. The performance of the proposed AGTC controllers is assessed in comparison to a baseline controller. The results highlight that the AGTC strategy without a filter effectively reduces lateral tower fatigue load at the expense of higher power signal oscillations and increased fatigue in the low-speed shaft. Using a filter in the AGTC mitigates these adverse effects, smoothing power oscillations to achieve similar values as the baseline control, and significantly reducing the load experienced in the low-speed shaft. The proposed methodology is robust and adaptable to various wind and wave conditions, demonstrating its ability to enhance the structural integrity of wind turbines without compromising power generation efficiency.