Complex state variables are used to study the dynamic behavior of induction motors considering the propagation in space of the distributed magnetic field inside the machine. The objective of this paper is to improve the dynamics of pulsewidth modulation inverters in medium-voltage drive systems. To keep the dynamic losses of the power devices at a tolerable level, the switching frequency must be below 1 kHz. The sampling rate of the digital signal processing system is then low which introduces considerable signal delay. The delay has an adverse influence on the dynamic behavior of the current control system. It introduces undesired cross coupling between the current components id and iq. The degree of cross coupling is described by a cross-frequency transfer function. It is shown that the mechanism of cross coupling is different and more adverse than the conventional theory discloses. A current controller structure having poles and zeroes of the single-complex type is synthesized. Cross coupling is completely eliminated at any low switching frequency. Experimental results demonstrate that high dynamic performance and zero cross coupling is achieved even at very low switching frequency.
This paper presents a method for permanent magnet synchronous motor rotor position estimation at low speed with high accuracy. The high-frequency voltage signal is injected into motor stator windings, and the corresponding current signal containing information of rotor position estimation error is demodulated. A Kalman filter is chosen as the rotor position observer to depress the nonlinear effect caused by inverter and improve the estimation accuracy at low speed. Simulation results show that this method is applicable to both steady state and dynamic state estimation of rotor position. With the method proposed, a DSP (TMS320F2812) based position control system is implemented and tested. The experimental results are also presented in this paper, which show that the proposed scheme can achieve high accuracy at low speed.
1 April 2024 in International Journal of Electrical Power & Energy Systems
Despite advances in multilevel inverters and wide bandgap switches, it is still very beneficial to operate high power inverters at low switching frequencies to reduce switching losses, which are critical to improving efficiency and extending the life of the systems. Much research has been done on the problem of controlling electrical drives at low switching frequencies, and in particular predictive methods offer very good approaches. This article deals with a classical method of predictive current control, namely the boundary-circle predictive scheme, and proposes its improvement by keeping the switching frequency close to a predefined level. This is achieved by controlling the radius of the boundary circuit. After deriving a linear relationship from the non-linear interaction between the boundary circle and the switching frequency, the proposed scheme dynamically adjusts the boundary circle to keep the inverter operation near the preset low frequency, thereby reducing switching losses while maximizing power device performance. The range of the switching frequency to be adjusted is determined according to the application, taking into account the trade-off between the quality of the current and the switching frequency. Experimental results from a laboratory setup confirm the effectiveness of the proposed method.