The achievement of ultraclean Ohmic van der Waals (vdW) contacts at metal/transition-metal dichalcogenide (TMDC) interfaces would represent a critical step for the development of high-performance electronic and optoelectronic devices based on two-dimensional (2D) semiconductors. Herein, we report the fabrication of ultraclean vdW contacts between indium (In) and molybdenum disulfide (MoS2) and the clarification of the atomistic origins of its Ohmic-like transport properties. Atomically clean In/MoS2 vdW contacts are achieved by evaporating In with a relatively low thermal energy and subsequently cooling the substrate holder down to ~100 K by liquid nitrogen. We reveal that the high-quality In/MoS2 vdW contacts are characterized by a small interfacial charge transfer and the Ohmic-like transport based on the field-emission mechanism over a wide temperature range from 2.4 to 300 K. Accordingly, the contact resistance reaches ~600 Ω μm and ~1000 Ω μm at cryogenic temperatures for the few-layer and monolayer MoS2 cases, respectively. Density functional calculations show that the formation of large in-gap states due to the hybridization between In and MoS2 conduction band edge states is the microscopic origins of the Ohmic charge injection. We suggest that seeking a mechanism to generate strong density of in-gap states while maintaining the pristine contact geometry with marginal interfacial charge transfer could be a general strategy to simultaneously avoid Fermi-level pinning and minimize contact resistance for 2D vdW materials.
We use an in situ Al decoration technique to control the transport characteristics of single-walled carbon nanotube field effect transistors (SWNT-FETs). Al nanoparticle decoration in a high vacuum caused the devices to change from p-type to n-type FETs, and subsequent exposure to the ambient atmosphere induced a gradual recovery of p-type character. In comparison with the bare SWNT-FETs under high vacuum, the channel-open devices with decorated Al particles exhibited reduced current under ambient conditions. However, selective Al decoration only at the contact resulted in an improved p-type current in ambient air.
Gallium phosphide (GaP) nanowire transistors were fabricated in back-gated structure, and their electrical characteristics were measured systematically in both air and vacuum. The transistors turn on typically between and in ambient air. However, a large threshold voltage shift, , toward negative gate bias was observed in vacuum. After the transistors were exposed to air for , returned to the similar value in ambient air, implying a reversible process. The rate of shift slows down when they were exposed to in comparison with that of air. The shift of is believed to be related to the charge transfer from the surface of GaP nanowire to the physically adsorbed OH or oxygen. In addition, the observed shift from the GaP nanowire transistors can be explained by the conventional -channel depletion mode metal-oxide-semiconductor field-effect transistor.
The microwave response of small stacks of intrinsic Josephson junctions in single crystals was studied. When irradiated with a microwave of frequencies higher than the junction plasma frequency, the supercurrent branch becomes resistive and splits into multiple subbranches. The number of subbranches turns out to be identical to the number of intrinsic Josephson junctions in the mesa within the experimental error. The behavior of the subbranches fits well the predicted Josephson fluxon dynamics in a strongly coupled stack of junctions.
Microwave response of individual multiwall carbon nanotubes was studied at low temperatures. With the irradiation of microwave, the slope of DC current–voltage characteristics change significantly, giving rise to enhanced linear-response conductance. The microwave power dependence of the linear conductance can be explained in terms of the photon-assisted transport. We have also observed some anomalous dip of the conductance at low microwave power.