The metal fueled steam Rankine cycle has been successfully applied to Unmanned Underwater Vehicles. However, the suitable turbine configuration is yet to be determined for this particular application. In this paper, the mean-line design approach based on the existing empirical correlations is first described. The corresponding partial admission axial and radial inflow turbines are then preliminarily designed. To assess the performance of designed turbines, the three-dimensional Computational Fluid Dynamics (CFD) simulations and steady-state structural analysis are performed. The results show that axial turbines are more compact than radial inflow turbines at the same output power. In addition, since radial inflow turbines can reduce the exit energy loss, this benefit substantially offsets the increment of the rotor losses created by the low speed ratios and supersonic rotor inlet velocity. On the contrary, due to the large volume of dead gas and strong transient effects caused by the high rotor blade length of radial inflow turbines, the overall performance between axial and radial inflow turbines is comparable (within 4%). However, the strength of radial inflow turbines is slightly superior because of lower blade inlet height and outlet hub radius. This paper confirms that the axial turbine is the optimal configuration for underwater vehicles in terms of size, aerodynamics and structural performance.
The performance of the gas–liquid mixture Roots pump at different operating conditions is investigated in this paper. The pump efficiency was first increased from 48% to 64%, and then decreased to 59% with the increased inlet CO2 volume fraction (from 0.8 to 1). The increased rotational speed (from 1000 rpm to 4000 rpm) and pressure ratio (from 2 to 10) can lead to a reduction in the pump’s efficiency from 67% to 43% and from 48% to 33%, respectively. The variation in the pump’s efficiency is affected by the volumetric efficiency and the flow efficiency simultaneously. The high pressure and the CO2 volume fraction in the outlet zone can increase the leakage, leading to a reduction in the volumetric efficiency. The flow efficiency decreases with the increase in the local pressure at the outlet zone and the backflow density. The outlet zone pressure can also affect the fluid properties by changing the density of the gas phase. Therefore, the combined effect of the outlet zone pressure and the working fluid properties is considered to be the main factor affecting the performance. This paper further explores the suitability of Roots pumps for compressing gas–liquid mixtures.