Despite the development of increasingly popular head mounted displays, CAVE-type systems may still be considered one of the most immersive virtual reality systems with many advantages. However, a serious limitation of most CAVE-type systems is the generation of a three-dimensional (3-D) image from the perspective of only one person. This problem is significant because in some applications, the participants must cooperate with each other in the virtual world. This paper presents the adaptation of a one-user Cave Automatic Virtual Environment (CAVE) installation in the Immersive 3-D Visualization Lab at the Gdańsk University of Technology to a two-user stereoscopy system. Simultaneous use of two alternative one-user stereoscopies available in the I3DVL (a technique with spectrum separation—Infitec, and active stereo) and a simple electronic circuit have allowed us to transform the one-user stereoscopy CAVE installation to a two-user stereoscopic system. The experiments performed concentrated on several objective measurable parameters. The calculated crosstalk value was low, approximately 1%, which can be considered negligible and shows the proper operation of the proposed technique. Additionally, initial experiments based on the tested two-user application and related to user comfort in the developed two-user stereoscopy are discussed in this paper. However, this topic still needs further research. The proposed solutions are a cheap alternative to adapt the existing one-user CAVE-type systems which support two projection techniques to a two-user system.
In recent years, many centers in the world attempted to build a virtual reality laboratory. The main idea of such laboratory is to allow the user to “immerse” into and move in a computer-generated virtual world. In the paper, the underlying principles of the system of virtual reality (VR) are described. The selected implementations constructed by the research centers of the world are also presented. The cave automatic virtual environment (CAVE) installation is planned to be implemented at the Gdańsk University of Technology. In this solution, the images will be projected on flat screens arranged in the form of a cube. The user will be located inside a transparent sphere freely rotating inside a cube, which allows simulation of free movement without changing the position of the screens. A walking motion of the user will trigger changes in the computer-generated images on screens surrounding the sphere thus creating an illusion of motion. The problems of visualization in the planned installation are outlined and discussed
Cultivation in controlled environmental conditions can provide good quality medicinal herbs with consistent properties. A sensing system that can determine the contents of medicinal substances in plants using spectral characteristics of leaves would be a valuable tool. Viability of such sensing approach for mint had to be confirmed experimentally, as no data correlating contents of medicinal substances with spectral characteristics of leaves are available, to the best of authors’ knowledge. In the first stage, presented in this paper, the influence of lighting on mint (Mentha rotundifolia) grown on a small hydroponic plantation was studied. Spectral characteristics of leaves were recorded by a spectrophotometer and colorimetric analysis was used to investigate the relationship between these characteristics and the spectrum of lighting. Dry mass yield was measured to test its dependence on the lighting. Dependence of chromaticity of leaves on the spectrum of light used in the cultivation was confirmed. Averaged spectra of leaves are distinguishable using a spectrophotometer and—in most cases—by a human observer. A partial correlation is observed between dry mass yield and the spectrum of lighting. Obtained results justify further research into the correlation between lighting and the contents of biological substances in medicinal plants using spectral characteristics of leaves.
1 September 2013 in Metrology and Measurement Systems