Yoshiki Takagiwa

Dr. Yoshiki Takagiwa

National Institute for Materials Science, Tsukuba, Japan
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 August 2020 in Journal of the American Chemical Society
Verified
Journal Article
Closed access
PJPriyanka Jood
Priyanka Jood
JMJames P. Male
James P. Male
SAShashwat Anand
Shashwat Anand
YMYoshitaka Matsushita
Yoshitaka Matsushita
YTYoshiki Takagiwa
Yoshiki Takagiwa
MOMichihiro Ohta
Michihiro Ohta

18 March 2019 in ACS Applied Materials & Interfaces
Verified
Journal Article
Open access
ZHZhufeng Hou
Zhufeng Hou
YTYoshiki Takagiwa
Yoshiki Takagiwa
YSYoshikazu Shinohara
Yoshikazu Shinohara
YXYibin Xu
Yibin Xu
KTKoji Tsuda
Koji Tsuda
Chemical composition alteration is a general strategy to optimize the thermoelectric properties of a thermoelectric material to achieve high-efficiency conversion of waste heat into electricity. Recent studies show that the Al2Fe3Si3 intermetallic compound with a relatively high power factor of ∼700 μW m–1 K–2 at 400 K is promising for applications in low-cost and nontoxic thermoelectric devices. To accelerate the exploration of the thermoelectric properties of this material in a mid-temperature range and to enhance its power factor, a machine-learning method was employed herein to assist the synthesis of off-stoichiometric samples (namely, Al23.5+xFe36.5Si40–x) of the Al2Fe3Si3 compound by tuning the Al/Si ratio. The optimal Al/Si ratio for a high power factor in the mid-temperature range was found rapidly and efficiently, and the optimal ratio of the sample at x = 0.9 was found to increase the power factor at ∼510 K by about 40% with respect to that of the initial sample at x = 0.0. The possible mechanism for the enhanced power factor is discussed in terms of the precipitations of the metallic secondary phases in the Al23.5+xFe36.5Si40–x samples. Furthermore, the maximum achievable thermal conductivity of Al2Fe3Si3 estimated by the Slack model is ∼10 W m–1 K–1 at the Debye temperature. An avoided-crossing behavior of the acoustic and the low-lying optical modes along several crystallographic directions is found in the phonon dispersion of Al2Fe3Si3 calculated by ab initio density functional theory method. These preliminary results suggest that Al2Fe3Si3 can have a low thermal conductivity. The calculated formation energies of point defects suggest that the antisite defects between Al and Si are likely to cause the Al and Si off-stoichiometries in Al2Fe3Si3. The theoretically obtained insight provides additional information for the further understanding of Al2Fe3Si3.

21 May 2021 in ACS Applied Materials & Interfaces
Verified
Journal Article
Open access
YTYoshiki Takagiwa
Yoshiki Takagiwa
ZHZhufeng Hou
Zhufeng Hou
KTKoji Tsuda
Koji Tsuda
TITeruyuki Ikeda
Teruyuki Ikeda
HKHiroyasu Kojima
Hiroyasu Kojima
To lower the introduction and maintenance costs of autonomous power supplies for driving Internet-of-things (IoT) devices, we have developed low-cost Fe–Al–Si-based thermoelectric (FAST) materials and power generation modules. Our development approach combines computational science, experiments, mapping measurements, and machine learning (ML). FAST materials have a good balance of mechanical properties and excellent chemical stability, superior to that of conventional Bi–Te-based materials. However, it remains challenging to enhance the power factor (PF) and lower the thermal conductivity of FAST materials to develop reliable power generation devices. This forum paper describes the current status of materials development based on experiments and ML with limited data, together with power generation module fabrication related to FAST materials with a view to commercialization. Combining bulk combinatorial methods with diffusion couple and mapping measurements could accelerate the search to enhance PF for FAST materials. We report that ML prediction is a powerful tool for finding unexpected off-stoichiometric compositions of the Fe–Al–Si system and dopant concentrations of a fourth element to enhance the PF, i.e., Co substitution for Fe atoms in FAST materials.

1 July 2018 in Journal of Physics and Chemistry of Solids
Verified
Journal Article
Closed access
YTYoshiki Takagiwa
Yoshiki Takagiwa
YIYukihiro Isoda
Yukihiro Isoda
MGMasahiro Goto
Masahiro Goto
YSYoshikazu Shinohara
Yoshikazu Shinohara

17 August 2017 in Journal of Thermal Analysis and Calorimetry
Verified
Journal Article
Closed access
PDF file
YTYoshiki Takagiwa
Yoshiki Takagiwa
YIY. Isoda
Y. Isoda
MGM. Goto
M. Goto
YSY. Shinohara
Y. Shinohara

15 October 2020 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
YTYoshiki Takagiwa
Yoshiki Takagiwa
TITeruyuki Ikeda
Teruyuki Ikeda
HKHiroyasu Kojima
Hiroyasu Kojima