Gyula Ferenc Vasvári

Mr. Gyula Ferenc Vasvári


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 March 2021 in Materials
Verified
Journal Article
Open access
PDF file
GVGyula Ferenc Vasvári
Gyula Ferenc Vasvári
ASAdam Schiffer
Adam Schiffer
TZTamás Zsebe
Tamás Zsebe
ÁSÁdám Schiffer
Ádám Schiffer
ISIvan Samardžić
Ivan Samardžić
Peter MarotiPeter Maroti
Peter Maroti
Additive manufacturing technologies based on metal melting use materials mainly in powder or wire form. This study focuses on developing a metal 3D printing process based on cold metal transfer (CMT) welding technology, in order to achieve enhanced productivity. Aluminium alloy test specimens have been fabricated using a special 3D printing technology. The probes were investigated to find correlation between the welding parameters and geometric quality. Geometric measurements and tensile strength experiments were performed to determine the appropriate welding parameters for reliable printing. The tensile strength of the product does not differ significantly from the raw material. Above 60 mm height, the wall thickness is relatively constant due to the thermal balance of the welding environment. The results suggest that there might be a connection between the welding parameters and the printing accuracy. It is demonstrated that the deviation of ideal geometry will be the smallest at the maximum reliable welding torch movement speed, while printing larger specimens. As a conclusion, it can be stated that CMT-based additive manufacturing can be a reliable, cost-effective and rapid 3D printing technology with enhanced productivity, but without significant decrease in mechanical stability.

13 November 2024 in Energies
Verified
Journal Article
Open access
PDF file
LBLászló Budulski
László Budulski
Gábor LochGábor Loch
Gábor Loch
LLLenkovics Lenkovics
Lenkovics Lenkovics
MBMihály Baumann
Mihály Baumann
Balázs CakóBalázs Cakó
Balázs Cakó
Dávid CsonkaDávid Csonka
Dávid Csonka
This paper describes experiments on finned tube heat exchangers, focusing on reducing the thermal contact resistance at the contact between the pipe and the lamella. Various contact materials, such as solders and adhesives, were investigated. Several methods of establishing contact were tested, including blowtorch soldering, brazing, and furnace soldering. Thermal camera measurements were carried out to assess the performance of the contact materials. Moreover, finite element analysis was performed to evaluate the contact materials and establish guidelines in the fin–tube connection modeling by comparing simplified models with the realistic model. Blowtorch brazing tests were successful while soldering attempts failed. During the thermographic measurements, reflective surfaces could be measured after applying a thin layer of paint with high emissivity. These measurements did not provide valuable results; thus, the contact materials were assessed using a finite element analysis. The results from the finite element analysis showed that all the inspected contact materials provided better heat transfer than not using a contact material. The heat transfer rate of the tight-fit realistic model was found to be 33.65 for air and 34.9 for the Zn-22Al contact material. This finding could be utilized in developing heat exchangers with higher heat transfer with the same size.