The integral impeller is a complex part characterized by highly curved surfaces. Modeling and interpolation methods for manufacturing integral impellers are currently the subject of intensive research. In this study, to represent the shape of the ruled-surface blades, third-order non-uniform rational B-splines are constructed from data points for the hub and shoulder on the pressure and suction sides of the blade. Various methods for determining the tool axis vector offset and the location of the tool center for a cylindrical ball cutter are developed and verified with simulations of machining operations. To obtain a smooth interpolation and high accuracy in machining, a third-order non-uniform rational B-spline interpolation algorithm for ruled-surface blades is developed. This method can create a smooth transition between the hub and the blade shoulders. The method is implemented in an open-architecture computer numerical control controller. Simulations and experimental tests of machining tasks are performed to verify the non-uniform rational B-spline interpolation method. The test results show that this interpolation technique can produce a smooth and continuous path along the axes of motion. The new technique has the advantages of requiring fewer lines of numerical control code and producing higher machining accuracy.
16 May 2016 in The International Journal of Advanced Manufacturing Technology
Cutter displacements and deflections induce a significant amount of surface error in machined thin-walled parts and are a major obstacle to achieving higher productivity in a five-axis milling operation. In this study, a milling force model for the five-axis flank milling process was established and implemented by calculating and simulating the cutter dynamic displacement to investigate the dynamic response of ruled surface impeller blades in the milling process. A machining trajectory and related machining parameters were selected to calculate the dynamic milling forces in the X and Y directions for each analysis time using the calculation method. Using ANSYS software, the milling forces in three directions were input into the finite element model of the ball-end milling tool. The deformation was analyzed using post-processing for the ruled surface milling. Then, the milling parameters related to the dynamic displacement of the tool in the side milling blade were trained and optimized using a back-propagation neural network and particle swarm optimization algorithm during the side milling of the ruled surface. In addition, processing experiments were performed based on the optimized parameters. The blade roughness tests indicated that the surface quality was considerably improved after optimization, thus verifying the feasibility of the optimization method.
The predecessor of China Optics was China Optics and Applied Optics Digest, which was founded in 1985. At that time, it was the only retrieval journal in the field of optics in China. At the end of 2008, China Optics and Applied Optics Digest was renamed 《中国光学》的前身是1985年创办的《中国光学与应用光学文摘》,当时是国内光学领域唯一的检索刊物。2008年底《中国光学与应用光学文摘》转型更名为《中国光学与应用光学》期刊,刊载内容突破了文摘的限制,正式成为学术刊物。
The predecessor of China Optics was China Optics and Applied Optics Digest, which was founded in 1985. At that time, it was the only retrieval journal in the field of optics in China. At the end of 2008, China Optics and Applied Optics Digest was renamed 《中国光学》的前身是1985年创办的《中国光学与应用光学文摘》,当时是国内光学领域唯一的检索刊物。2008年底《中国光学与应用光学文摘》转型更名为《中国光学与应用光学》期刊,刊载内容突破了文摘的限制,正式成为学术刊物。
15 December 2016 in The International Journal of Advanced Manufacturing Technology