In this paper, we analyze the theoretical impact of the Molybdenum (Mo) back contact and the MoSe 2 interfacial layer on the performances of a Cu 2 ZnSnSe 4 (CZTSe)-based solar cell. MoSe 2 layers are formed spontaneously in the Mo/CZTSe interface during the annealing of the absorber, but disagreeing interpretations about their actual role in affecting the device figures of merit (VOC , JSC , FF, and η) have been proposed in the literature. In our approach, we have simulated three structures presenting different conditions at the back contact: ideal-contact/CZTSe (flat-band), Mo/CZTSe, and Mo/MoSe 2 /CZTSe. For these three layers, an accurate explanation of the selection of critical material parameters is given. The numerical simulations, performed with SCAPS 3.2.01, show that the low values of Mo work function (≤4.95 eV) would have a strong detrimental effect on the VOC and FF of the cell if no interfacial layers were present at the Mo/CZTSe interface. On the other hand, a beneficial effect of the MoSe 2 layer on the VOC of the device is demonstrated when this layer is included in the structure. This trend is confirmed by experimental measurements. The expected band diagram of the full ZnO/CdS/CZTSe/MoSe 2 /Mo structure is provided.
1 December 2016 in Solar Energy Materials and Solar Cells
Increasing demand of wireless devices contributes to radiofrequency (RF) congestion. Light Fidelity (LiFi) promises to be an interesting alternative by using the visible part of the electromagnetic spectrum instead of the RF part as nearly all existing wireless transmission systems do. A basic LiFi system is composed of one intensity-controlled light-emitting diode (LED) and one receiver device sensitive to very high-frequency (thus invisible to human sight) modulations of the luminous intensity. In most cases, the photoreceptor is a silicon photodiode of PIN (P-type intrinsic N-type) or APD (Avalanche photodiode) conception. Recently, a few studies suggest that photovoltaic (PV) modules could be used to implement outdoor LiFi transmissions, i.e., under direct sunlight exposure. In this paper, we propose to compare the behavior of a PV module and a commercial APD-based photodetector (without any optical lens or colored filter) for experimental LiFi transmissions on both indoor and outdoor conditions. The performance of the two solutions is quantified in terms of various frequency responses like attenuation, signal-to-noise ratio, or bit-error rate. The results show that, while the photodiode exhibits very good performance in indoor conditions, its frequency response is rapidly deteriorating when a sunlight exposure of more than $200 W/m^2$ is superimposed over the LiFi signal. We demonstrate that a PV module in $V_{oc}$ (open-circuit voltage) condition still operates a LiFi transmission under additional solar illumination.
Defect levels in CdTe doped with Bi are studied by low temperature photoluminescence, photoinduced current transient spectroscopy, photoconductivity measurements, and optical absorption. Two centers associated with the doping with Bi are reported. The first one, a deep level located at , only present at low dopant concentrations, has donor character and hole-trap properties, and is mainly responsible for the high resistivity and very high photoconductivity of the samples. The second one, an acceptor center located at , assigned to species, is only present at high dopant concentrations and is mainly responsible for the low resistivity and poor photoconductivity of these samples.