In this article, we propose a new actuator named the modular bio-actuator (MBA). The MBA has two tendon structures made of polydimethylsiloxane (PDMS) at both ends of the bio-actuator. The MBA can be easily handled and fixed on an artificial micro-robot body to increase its design flexibility and output power. The tendon structures were connected to a bio-actuator in the form of a chain structure, and the connection between the tendon structures and the bio-actuator was maintained for more than three weeks. The contraction length of the MBA was linearly increased when the DC voltage applied to the MBA was increased. The MBA contracted over 200 µm when a DC voltage of 10 V and 1 Hz was applied to the bio-actuator. The output power of the MBA was measured using a PDMS cantilever, and the total output power of the MBA increased linearly when multiple MBAs were stacked on a PDMS cantilever. This study was aimed at improving the design flexibility and controllability of micro-robots and bionic systems.
Bioactuators have been developed in many studies in the recent decade for actuators of micro-biorobots. However, bioactuators have not shown the same power as animal muscles. Centrifugal force was used in this study to increase the cell density of cultured muscle cells that make up the bioactuator. The effect of the centrifugal force on cells in the matrix gel before curing was investigated, and the optimal centrifugal force was identified to be around 450× g. The compressed modular bioactuator (C-MBA) fabricated in this study exhibited 1.71 times higher cell density than the conventional method. In addition, the contractile force per unit cross-sectional area was 1.88 times higher. The proposed method will contribute to new bioactuators with the same power as living muscles in animals.