Wydawnictwo SIGMA-NOT wydaje czasopisma fachowe informuj?ce swoich czytelnik?w o najnowszych osi?gni?ciach naukowych i nowoczesnych rozwi?zaniach technicznych w Polsce i na ?wiecie, popularyzuje problemy techniczne oraz poszerza wiedz? i kultur? techniczn?.

Shallots (Allium cepa L. Aggregatum group) are cultivated on small areas, mostly to harvest mature bulbs with dry scales. Due to their exceptional taste and nutritional value, and a short growing season, they can also be grown for early bunch harvest. New shallot cultivation strategies are being sought to meet consumers’ growing expectations regarding the quality of vegetables, and their increasing awareness of global food safety. Therefore, the aim of this study was to evaluate the effect of selected biostimulants on the biometric parameters, yield and nutritional value of shallot bulbs and leaves. The experimental factors were as follows: two biostimulant types—Effective Microorganisms (EM) and Goëmar Goteo (GG), two shallot cultivars—Bonilla F1 and Matador F1, grown for bunch harvest, and year of the study. Shallot leaves had a higher content of L-ascorbic acid, reducing sugars and nitrates than bulbs. Young bulbs had a higher content of DM and total sugars than leaves. The leaves and bulbs of shallot plants treated with EM accumulated the highest amounts of minerals. Macronutrient ratios were closer to optimal in shallot leaves than bulbs. The nitrate content of bulbs was inversely proportional to the nitrate content of leaves. Therefore, an increase in the nitrate content of leaves by around 330% led to an approximately 40% decrease in the nitrate content of bulbs. The correlations between the parameters of the chemical composition of shallots and shallot leaves show that the increase in the dry matter content of the bulbs (by approx. 60%) was accompanied by an increase in the L-ascorbic acid content in the leaves (by approx. 240%). The use of biostimulants in the cultivation of A. cepa L. Aggregatum group contributed to the reduction of L-ascorbic acid content in bulbs and had no positive effect on the leaves. Moreover, no positive effect of biostimulants on the reduction of nitrate content in shallot leaves and bulbs was observed, which is undesirable from the consumer’s point of view. After the use of biopreparations, the yield of shallots was lower than that of the control—by approx. 14% (EM) and approx. 4% (GG). Therefore, the measurable benefits of biostimulants in the cultivation of shallots grown for early bunch harvest do not balance the costs of their purchase and use.

Research Highlights: The correlations between seed mass and the remaining physical properties were determined in selected fir species, and a method for seed sorting was proposed to promote uniform germination and emergence. Background and Objectives: Information about the variation and correlations between the physical properties of seeds is essential for designing and modeling seed processing operations such as seed separation. The aim of this study was to determine the range of variation in the physical properties of seeds in eleven fir species, and to analyze the correlations between these parameters to improve the seed sorting process. Materials and Methods: Terminal velocity, thickness, width, length, the angle of external friction and mass were determined in the seeds of 11 fir species. The measured parameters were used to calculate the geometric mean diameter, three aspect ratios, sphericity index and the specific mass of each seed. Results: The seeds of Sierra white fir where most similar, whereas the seeds of balsam fir differed most considerably from the seeds of the remaining fir species. In the majority of the analyzed fir species, seed mass was most strongly correlated with terminal velocity, followed by thickness. Conclusions: Fir seeds should be sorted primarily with the use of mesh sieves with longitudinal openings to obtain fractions with similar seed mass and to eliminate the need for dewinging.

The objective of this study was to evaluate the effects of the friction plate hardness and surface orientation of a friction plate on the angle and coefficient of static friction of cereal kernels. The angle of static friction of kernels representing four major cereal species was measured on six friction plates with different hardness. The friction plates were placed in position where their surface orientation was perpendicular or parallel relative to their inclination tilt. The experimental material comprised the so-called flat seed units, where each unit consisted of three spaced kernels. The angle of static friction of every flat seed unit was measured with a dedicated device in three replications, and average values of that angle were calculated. The kernels’ angle of static friction varied considerably from 13° to 33° within the analyzed range of changes in the surface characteristics of friction plates. The average angle of static friction was influenced mainly by the surface orientation of the friction plate that came into contact with cereal kernels. The angle of static friction was 17.5% to 56.5% higher when the friction plate had perpendicular rather than parallel surface orientation. The frictional properties of kernels were less influenced by plate hardness, and clear relationships were not observed in this respect. The kernels’ coefficient of static friction remained fairly constant within the analyzed range of plate hardness values, and it was estimated at 0.4 on plates with a perpendicular surface orientation and at 0.3 on plates with a parallel surface orientation.

Soil affects plant growth and development, and it is one of the factors that determine crop yields and quality. Broccoli (Brassica oleracea var. italica Plenck) plants cv. Cezar were grown in an experiment conducted in 2021–2022 on a horticultural farm. The biometric parameters of broccoli plants were determined in the first stage. The chemical composition of the edible parts of broccoli was determined in the second stage, which involved two experimental factors. The first factor was the edible parts of broccoli: florets, leaves, and stalks. The second factor was the effect of soil type on the chemical composition of the edible parts of broccoli. Albic Luvisol (II) had a significant positive effect on floret height and the number of florets. Leaf yield was significantly lower when broccoli plants were grown in Eutric Cambisol (I) compared with Albic Luvisol (II) and degraded chernozem (III). Soil type had no significant influence on the macronutrient content of broccoli florets, leaves, and stalks, but the accumulation of macronutrients varied across the edible plant parts. The content of iron, zinc and manganese in broccoli plants was not significantly affected by soil type, but soil type exerted a significant effect on copper content.