Laboratory of Membrane and Catalytic Processes, Nanotechnology and Biotechnology Department, Nizhny Novgorod State Technical University n.a. R.E. Alekseev, Nizhny Novgorod, Russia
Dr. Maxim Trubyanov
Laboratory of Membrane and Catalytic Processes, Nanotechnology and Biotechnology Department, Nizhny Novgorod State Technical University n.a. R.E. Alekseev, Nizhny Novgorod, Russia
Nowadays, the imidazolium-based ionic liquids containing acetate counter-ions are attracting much attention as both highly selective absorbents of the acidic gases and CO2 carriers in the supported ionic liquid membranes. In this regard, the investigation of the gas transport properties of such membranes may be appropriate for better understanding of various factors affecting the separation performance and the selection of the optimal operating conditions. In this work, we have tested CH4, CO2 and H2S permeability across the supported ionic liquid membranes impregnated by 1-butyl-3-methylimidazolium acetate (bmim[OAc]) with the following determination of the ideal selectivity in order to compare the facilitated transport membrane performance with the supported ionic liquid membrane (SILM) that provides solution-diffusion mechanism, namely, containing 1-butyl-3-methylimidazolium tetrafluoroborate (bmim[BF4]). Both SILMs have showed modest individual gases permeability and ideal selectivity of CO2/CH4 and H2S/CH4 separation that achieves values up to 15 and 32, respectively. The effect of the feed gas mixture composition on the permeability of acidic gases and permeselectivity of the gas pair was investigated. It turned out that the permeation behavior for the bmim[OAc]-based SILM toward the binary CO2/CH4, H2S/CH4 and ternary CO2/H2S/CH4 mixtures was featured with high acidic gases selectivity due to the relatively low methane penetration through the liquid phase saturated by acidic gases.
1 December 2013 in Russian Journal of Applied Chemistry
An effect of a simultaneous increase in pressure, temperature, and loading density on the efficiency of mass transfer in a packed distillation column was experimentally and theoretically examined in deep purification of liquefied gases. It was found and experimentally confirmed that the increase in pressure and temperature in the column enables intensifying mass transfer, as well as improving performance and lowering energy consumption of the purifying process.
1 November 2018 in Journal of Physics: Conference Series
The feasibility of using thermodynamic simulation models for describing the VLE behaviour of dilute ammonia-impurity solutions during high purification of R717 refrigerant by distillation is discussed. A comprehensive evaluation of different thermodynamic models (EoS-, LACT-based, combined EoS-LACT, predictive) has been done by comparing the simulation results with published experimental VLE data for ammonia-based dilute solutions in the pressure/temperature range from the boiling point of ammonia up to the critical point. The behaviour of the three important impurity groups (permanent gases, hydrocarbons, and water) in high-purity ammonia is considered in the dilute region. The studied systems are characterised by non-ideality, combine components from different chemical classes and with different polarity, contain subcritical and supercritical components, and can form associates in liquid and vapour phase. The results show that, depending on the system and the operating pressure, various modelling approaches can be successfully employed in the simulation of distillation-based separations involving VLE of non-ideal highly diluted ammonia-based mixtures. Equally important is the type of mixing rules, as well as the quality of the binary interaction parameters used in the relations. The usage of some of the predictive methods is shown to be a sensible option for a preliminary design.