Induction heating (IH) technology is nowadays widely present in domestic appliances because of its cleanness, high efficiency, and faster heating process. All of these advantages are due to its heating process, where the pot is directly heated by the induced currents generated with a varying magnetic field. As a result, the glass where the pot is supported is not directly heated and, consequently, efficiency and heating times are improved. IH systems are based on dc-link inverters to generate the required alternating current to feed the inductor. Usually, resonant converters are used to achieve higher efficiencies and power densities. In such systems, the maximum output power and efficiency are achieved at the resonant frequency, and the switching frequency is increased to reduce the output power. As a consequence, in these converters, the efficiency is also reduced in the low-medium output power range. This paper proposes the use of the half-bridge inverter in two operating modes to achieve higher efficiency in a wide output power range. The power converter topology can be reconfigured by changing the resonant capacitors through electromechanical relays. As a consequence, the entire efficiency of the cooking process is improved with a cost-effective procedure.

This paper presents the analysis and design of a new ac-ac resonant converter applied to domestic induction heating. The proposed topology, based on the half-bridge series resonant inverter, uses only two diodes to rectify the mains voltage. The proposed converter can operate with zero-voltage switching during both switch-on and switch-off transitions. Moreover, this topology doubles the output voltage, and therefore, the current in the load is reduced for the same output power. As a consequence, the converter efficiency is significantly improved. The analytical and simulation results have been verified by means of a 3600-W induction heating prototype. An efficiency study has been carried out, obtaining values higher than 96%.

Induction heating systems are the technology of choice in many industrial, domestic, and medical applications due to its high performance. The core component of such systems is the power supply, which is usually composed of a rectifier stage and a resonant inverter. In order to simplify and further optimize the performance of the power supply, a class-E direct ac-ac converter featuring multicycle modulations is proposed in this paper. The proposed converter is composed of two switching devices that enable the direct ac-ac conversion. Single- and multicycle operation modes have been analytically described to prove the benefits, in terms of peak voltage reduction and output power control capabilities. A prototype featuring SiC junction-gate field-effect transistor devices, which perfectly fit these applications, has been designed and built to prove the feasibility of the proposed converter. The experimental results match the analytical results and validate the benefits of this converter.

Efficiency is a key design parameter when designing the power converters for domestic induction heating applications, since it determines not only the environmental impact of the power converter but also its final performance and reliability. In this paper, the design of high-efficiency converters for induction heating applications is discussed, focusing on the advantages of using wide bandgap devices. As a conclusion, a multiple-output boost resonant ac-ac converter is proposed, significantly improving current state-of-the-art efficiency and achieving a reduced component-count solution for multiple-load systems. The proposed converter has been tested through a dual-output boost resonant inverter for domestic induction heating applications. The design procedure is detailed, including the design of an optimized gate drive circuit for this application. Experimental results show significant improvements in efficiency in the whole operating range, and an accurate output power control, proving the benefits and feasibility of the proposed SiC-based converter.

Domestic induction heating (IH) is currently the technology of choice in modern domestic applications due to its advantages regarding fast heating time, efficiency, and improved control. New design trends pursue the implementation of new cost-effective topologies with higher efficiency levels. In order to achieve this aim, a direct ac-ac boost resonant converter is proposed in this paper. The main features of this proposal are the improved efficiency, reduced component count, and proper output power control. A detailed analytical model leading to closed-form expressions of the main magnitudes is presented, and a converter design procedure is proposed. In addition, an experimental prototype has been designed and built to prove the expected converter performance and the accurateness of the analytical model. The experimental results are in good agreement with the analytical ones and prove the feasibility of the proposed converter for the IH application.