Amorphous (a-) Sb2S3 nanoparticle aggregates were synthesized using a facile polyol-mediated process at room temperature and their Na-ion storage capability was evaluated. Owing to the spherical nano-aggregate morphology and amorphous structure, the a-Sb2S3 anode exhibited superior rate capability and cycling stability compared to that of crystalline, microscale Sb2S3 particles. The a-Sb2S3 electrode was also examined as an anode for eco-friendly, Na metal-free seawater flow batteries.
The energy storage performance of lithium-ion batteries (LIBs) depends on the electrode capacity and electrode/cell design parameters, which have previously been addressed separately, leading to a failure in practical implementation. Here, we show how conformal graphene (Gr) coating on Ni-rich oxides enables the fabrication of highly packed cathodes containing a high content of active material (~99 wt%) without conventional conducting agents. With 99 wt% LiNi0.8Co0.15Al0.05O2 (NCA) and electrode density of ~4.3 g cm-3, the Gr-coated NCA cathode delivers a high areal capacity, ~5.4 mAh cm−2 (~38% increase) and high volumetric capacity, ~863 mAh cm-3 (~34% increase) at a current rate of 0.2 C (~1.1 mA cm-2); this surpasses the bare electrode approaching a commercial level of electrode setting (96 wt% NCA; ~3.3 g cm-3). Our findings offer a combinatorial avenue for materials engineering and electrode design toward advanced LIB cathodes.
Low-cost oxygen evolution/reduction reaction (OER/ORR) catalysts are critically important for energy conversion/storage systems. Here, a porous carbon (PC) catalyst is prepared as a low-cost catalyst from grapefruit peel biowaste using a facile hydrothermal carbonization combined with a chemical activation process. When examined as an OER/ORR catalyst in seawater, the PC exhibits an unexpected, highly efficient catalytic activity. From density functional theory (DFT) calculations, we found that sp3-bonded carbon atoms, zigzag edges with or without –COOH and –OH, and armchair edges with –O– are responsible for its superior OER/ORR activity. The suitability of the PC as a catalyst is tested in the half-cell of a Na/seawater battery, which exhibits a decreased voltage gap of ∼0.47 V between charge and discharge voltage curves. This value is even lower than those of Pt/C (∼0.68 V), IrO2 (∼0.66 V) and MnO2 (∼0.73). Also, a full cell of the metal-free seawater battery is assembled using hard carbon and PC as an anode and a catalyst, respectively. The full cell shows a lower voltage gap (∼0.65 V) with the voltage efficiency of ∼83–84% and excellent cycle life over 100 cycles. Our results confirm PC derived from grapefruit peels as an alternative to expensive Pt/C and IrO2 catalysts for the OER/ORR activities in seawater batteries.
A new energy conversion and storage system, named the ‘seawater battery’, has recently been a subject of research in the field of electrochemistry. Using natural seawater as the catholyte in an open-structured cathode, the battery stores sodium (Na) ions from the seawater on the anode side during charging, and then delivers electricity by discharging on demand. Herein, we report an amorphous red phosphorus/carbon composite anode material which was successfully employed as the anode of a seawater battery. It exhibited a stable cycling performance with a high reversible capacity exceeding 920 mA h gcomposite−1 with a coulombic efficiency of more than 92% over 80 cycles, as well as good rate capabilities. In terms of the full-cell performance of lithium ion and sodium ion batteries, the seawater batteries with the amorphous red phosphorus/carbon composite anode exhibited the highest reversible capacity and specific energy. These results indicate that the use of an open-structured cathode system, which provides the anode with an unlimited supply of Na ions, would allow a seawater battery to overcome the limitations associated with the high-capacity alloying reaction-based anodes used in conventional batteries with a closed system.